LEDLyskilder R14 Ultrathin Touch Slide RF Remote Controller
Touch color slide/RGB+W/Wireless remote 30m distance/CR2032 battery/Magnet stuck fix
Features
- Apply to RGB+W LED controller.
- Ultra sensitive color adjustment touch slide.
- Each remote can match one or more receivers.
- CR2032 battery powered.
- Operate with LED indicator light.
- Magnet on the back which can be easily stuck on back holder or any metal surfaces.
Technical Parameters
Input and Output | |
Output signal | RF(2.4GHz) |
Working voltage | 3VDC(CR2032) |
Working current | <5mA |
Standby current | <10μA |
Standby time | 1 year |
Remote distance | 30m(Barrier-free space) |
Safety and EMC | |
EMC standard (EMC) | ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4 |
Safety standard(LVD) | EN 62368-1:2020+A11:2020 |
Radio Equipment(RED) | ETSI EN 300 328 V2.2.2 |
Certification | CE,EMC,LVD,RED |
Environment | |
Operation temperature | Ta: -30 OC ~ +55 OC |
IP rating | IP20 |
Mechanical Structures and Installations
To fix the remote, three options are offered for selection:
- Option 1: stuck the remote on any metal surfaces directly.
- Option 2: fix the remote’ back holder on the wall with two screws.
- Option 3: adhere the remote’ back holder to the wall with a paster
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
- Match:
Short press the match key, and immediately press on/off key on the remote. The LED indicator fast flash a few times means the match is successful. - Delete:
Press and hold the match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.
Use Power Restart
- Match:
Switch off the power, then switch on the power, and repeat again. An immediately short press on/off key 3 times on the remote. The light blinks 3 times means the match is successful.
Delete:
Switch off the power, then switch on the power, and repeat again. An immediately short press on/off key 5 times on the remote. The light blinks 5 times means all matched remotes were deleted.
Key function
- Short press for On/Off.
- Press and hold 1-6s for RGB brightness dimming.
- Fast press 2 times for shift between RGB, W, and RGB+W mode. In RGB or RGB+W mode, touch the slide to change the RGB color. In W mode, touch slide to change the white brightness.
Safety information
- Read all instructions carefully before you begin this installation.
- When installing the battery, pay attention to the battery’s positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
- If no response from the receiver, please re-match the remote.
- Gently handle the remote, beware of falling.
- For indoor and dry location use only.
Documents / Resources
![]() |
LEDLyskilder R14 Ultrathin Touch Slide RF Remote Controller [pdf] Instruction Manual R14 Ultrathin Touch Slide RF Remote Controller, R14, Ultrathin Touch Slide RF Remote Controller |