Ultrathin Touch Slide RF Remote Controller
Model No.: R10
Touch color slide/RGB+CCT/Wireless remote 30m distance/CR2032 battery/Magnet stuck fix
Features
- Apply to RGB+CCT, dual color or RGB LED controller.
- Ultra sensitive color adjustment touch slide.
- Each remote can match one or more receiver.
- CR2032 battery powered.
- Operate with LED indicator light.
- Magnet on the back which can be easily stuck on back holder or any metal surfaces.
Technical Parameters
| Input and Output | |
| Output signal | RF(2.4GHz) |
| Working voltage | 3VDC(CR2032) |
| Working current | < 5mA |
| Standby current | < 10μA |
| Standby time | 1 year |
| Remote distance | 30m(Barrier-free space) |
| Warranty | |
| Warranty | 5 years |
| Safety and EMC | |
| EMC standard (EMC) | ETSI EN 301 489-1 V2.2.3 ETSI EN 301 489-17 V3.2.4 |
| Safety standard(LVD) | EN 62368-1:2020+A11:2020 |
| Radio Equipment(RED) | ETSI EN 300 328 V2.2.2 |
| Certification | CE, EMC, LVD, RED |
| Environment | |
| Operation temperature | Ta: -30°C ~ +55°C |
| IP rating | IP20 |
Mechanical Structures and Installations
- CR2032 Battery
- Note: Before the first use, please remove the protective film on the battery.
- Back holder with magnet
To fix the remote, three options are offered for selection:
Option 1: stuck the remote on any metal surfaces directly.
Option 2: fix the remote’ back holder on the wall with two screws.
Option 3: adhere the remote’ back holder to the wall with paster.
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
Match:
Short press match key, immediately press on/off key on the remote.
The LED indicator fast flash a few times means match is successful.
Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.
Use Power Restart
Match:
Switch off the power, then switch on power, repeat again.
Immediately short press on/off key 3 times on the remote.
The light blinks 3 times means match is successful.
Delete:
Switch off the power, then switch on power, repeat again.
Immediately short press on/off key 5 times on the remote.
The light blinks 5 times means all matched remotes were deleted.
Key function
- 1. Short press for On/Off.
2. Press and hold 1-6s for brightness dimming.
3. When light is on, fast press 2 times for shift between RGB and CCT touch slide. - R 100%
- Color touch slide
- G 100%
- B 100%
- WW 0%
CW 100% - WW 50%
CW 50% - WW 100%
CW 0% - LED indicator
Safety information
- Read all instructions carefully before you begin this installation.
- When installing battery, pay attention to the battery positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
- If no response from the receiver, please re-match the remote.
- Gently handle remote, beware of falling.
- For indoor and dry location use only.
User Manual Ver 1.0.3
Documents / Resources
 |
SKYDANCE R10 Ultrathin Touch Slide RF Remote Controller [pdf] Instructions R10, Ultrathin Touch Slide RF Remote Controller, R10 Ultrathin Touch Slide RF Remote Controller |
