LEAP SENSORS 53-100187-28 Leap Wireless Sensor System
Copyright and Trademarks
No part of this product or related documentation shall be reproduced in any form by any means without prior written authorization of Phase IV Engineering, Incorporated. No part of this document shall be reproduced, stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission from Phase IV Engineering, Incorporated.
Although every precaution has been taken in the preparation of this document, Phase IV Engineering assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein.
Phase IV Engineering assumes no responsibility for any loss or claims by third parties that may arise through the use of this product.
Phase IV Engineering assumes no responsibility for any damage or loss caused by deletion of data as a result of malfunction, repairs, or battery replacement, or power failure.
Phase IV Engineering, Incorporated may have patents, patent applications, trademarks, copyrights, or other intellectual property rights covering subject matter in this document. Except as expressly provided in any written license agreement from Phase IV Engineering, the furnishing of this document does not give you any license to these patents, trademarks, copyrights, or other intellectual property.
This manual, its related hardware, software and documentation are subject to change without notice and do not represent a commitment on the part of Phase IV Engineering. Phase IV Engineering reserves the right to make changes in the product design without reservation and without notification to its users.
© 2024 by Phase IV Engineering, Incorporated, 2820 Wilderness Place, Unit C, Boulder, Colorado 80301, USA. All rights reserved.
All brands and product names are trademarks or registered trademarks of their respective owners.
About this Manual
This manual contains general information about field wiring sensors to the Leap device node. It is designed to be used either as a reference tool or as a step-by-step guide to connect various sensors to the circuit board inside the Leap device node. This manual is only supplemental to standard Phase IV manuals and only contains specifics about making the low-voltage connections inside the node enclosure.
Audience
This manual assumes that you are already familiar with the [to be installed] sensor connection methods and responsible for installing and wiring the system.
Chart Industries Node
Sensor cable code
3-wire sensor cable pin out – see section 4 for different sensor type connections
IP Cable code
Pinout of Leap Circuit Boards
Multi-Sensor Board
TERMINAL BLOCK LAYOUT
TERMINAL BLOCK PINS ARE NUMBERED FROM LEFT TO RIGHT
Multi-Sensor Board – Motor Monitor – Lite
TERMINAL BLOCK LAYOUT
TERMINAL BLOCK PINS ARE NUMBERED FROM LEFT TO RIGHT
Sensor Wiring
Wireless Analog Input – 4-20mA, 0-5V, 0-10V
4-20mA loop powered (2-wire), 24V excitation
4-20mA loop powered (3-wire), 24V excitation
0-10V, self powered
0-10V, 24V excitation
4-20mA and 0-10V equivalent for Multi-Sensor Board
Panel Connector Pinout
Panel Connectors – Node Side
Panel Connectors – Node Side – variation option
Panel Connector – Cable Side – Unshielded
Panel Connector – Cable Side – Shielded
Technical Support
For more information about our products and services, or for technical assistance:
Visit us at: www.phaseivengr.com
Tel: +(303) 443 6611 (USA – MST 8:00 a.m. to 5:00 p.m., Mon.-Fri.)
E-Mail: support@phaseivengr.com
If you need assistance, please provide the product part number, product serial number, and product version.
Documents / Resources
 |
LEAP SENSORS 53-100187-28 Leap Wireless Sensor System [pdf] Instruction Manual 53-100187-28 Leap Wireless Sensor System, 53-100187-28, Leap Wireless Sensor System, Wireless Sensor System, Sensor System |