tp-link DS-PMA Combo Class Module
Install the Transceiver
- Wear an ESD-preventive wrist or ankle strap to prevent ESD damage to the transceiver.
- Insert the transceiver into the slot and firmly press it into place.
- Remove the protective dust plug from the transceiver.
- Plug a fiber-optic cable into the transceiver. Note that the transceiver works without any additional configuration
Remove the Transceiver
- Wear an ESD-preventive wrist or ankle strap to prevent ESD damage to the transceiver.
- Disconnect the network fiber-optic cable from the transceiver
- Pull the safety latch downwards to release the transceiver, and then pull it out from the slot
- Reinstall the protective dust plug in the transceiver’s optical bores and place it on an antistatic mat or a static shielding bag.
Note:
- Do not touch the output pins on the transceiver with your hand.
- Always keep the protective dust plug on the transceiver’s optical bores until you are ready to make a connection.
Caution:
DO NOT point or stare directly into the beam or into the optical port of the transceiver when it is operating, as this can injure your eyesight
Connection
Specifications
General Specifications
Safety Information
- Keep the device away from water, fire, humidity, or hot environments.
- Keep the device away from fire or hot environments.
- DO NOT immerse in water or any other liquid.
- Do not attempt to disassemble, repair, or modify the device.
- Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
- Do not point or stare directly into the beam or into the optical port of the transceiver when it is operating, as this can injure your eyesight.
EU Declaration of Conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2011/65/EU, and (EU)2015/863. The original EU Declaration of conformity may be found at https://www.tp-link.com/en/support/ce/
UKCA Declaration of Conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of the Electromagnetic Compatibility Regulations 2016 and Electrical Equipment (Safety) Regulations 2016. The original UK Declaration of Conformity may be found at
https://www.tp-link.com/support/ukca/
CONTACT
For technical support and other information, please visit https://www.tp-link.com/support, or simply scan the QR code
Documents / Resources
 |
tp-link DS-PMA Combo Class Module [pdf] Installation Guide DS-PMA-Combo C, DS-PMA-C, DS-PMA-C, DS-PMA Combo Class Module, DS-PMA, Combo Class Module, Class Module, Module |
