quick guide bsp
Battery Status Processor
Instruction Manual
swiss made power
designed and assembled by studer in Switzerland
Introduction
Congratulations !
You are about to install and use a high-end equipment that will play a central role in the energy management of your battery-based system. The bsp is a battery status processor for advanced monitoring of lead-acid batteries within an xtender system. This device has been designed, manufactured, assembled and tested in our factory in Switzerland. It has a 5-year warranty.
General Information
Exclusion of liability
Studer disclaims all responsibility and liability for damage, costs or losses resulting from an installation that does not comply with the instructions, a faulty operation or inadequate maintenance. The use of studer equipment is in any case under the responsibility of the customer.
Read carefully the safety and operation instructions
Installation must be entrusted to qualified personnel
Check the user manual online
Need help ?
https://eqrcode.co/a/Ecznzt
Compatible with :
Mounting and installation
Storage and content
Mounting place
The bsp should only be installed by qualified personnel.
Fixing and dimensions
Wiring
The device must be installed in accordance with local standards and regulations in force.
Measurement cables
Cables included :
- black&yellow (b) to shunt, confirm orientation
- blue (c) to shunt, confirm orientation
- red (d) to bat +, fuse included (500mA)
Multi units and power up
- bsp per system
Display
Display system
Configuring the xtender
Technical data
IP 20
| Supply voltage range | 7 … 85Vdc |
| Supply current | 9 mA @ 12V 5 mA @ 24V 3 mA @ 48V |
| Input voltage range | 7 … 85Vdc |
| Shunt measurement input range | ± 195 mV |
| RMS continuous current @ 25°C | ± 500 A (bsp 500) ± 1200 A (bsp 1200) |
| Maximum measurable peak current | ± 1950 A (bsp 500) ± 4680 A (bsp 1200) |
| Voltage measurement accuracy | 0.30% |
| Current measurement accuracy | 0.50% |
| Battery capacity | 20 … 20000 Ah |
| Operating temperature range | -20 … 55°C |
Maintenance and recycling
Maintenance and recycling
Except for the periodic check of the connections (tightening, general condition), the bsp does not require any particular maintenance. To dispose of this product, please use the service for the collection of electrical waste and observe all obligations in force in the place of purchase.
Serial Number :…………………………..
Installed by :………………………………..
Date :………………………………………
Signature :…………………………………..
Call our specialists +41 27 205 60 80
or visit studer-innotec.com/support
Studer Innotec SA
rue des Casernes 57
1950 Sion, Switzerland
info@studer-innotec.com
© All rights reserved
Studer Innnotec SA – V1.0
Documents / Resources
 |
STUDER bsp Battery Status Processor [pdf] Instruction Manual bsp Battery Status Processor, bsp, Battery Status Processor, Status Processor, Processor |
