myFirstech-logo

myFirstech DL-CH12 Cherokee TIP Start

myFirstech-DL-CH12-Cherokee-TIP-Start-product

FTI-CDP1 – DL-CH12 – Type 5 2014-18 Jeep Cherokee TIP Start

FIRMWARE

This installation requires the BLADE-AL (DL)-CH12 firmware, the flash module, and the firmware update of the driver before installation.

FACILITY

Type 5 vehicles use CAN connections in the harness at the OBD-II connector, the connection cable is not required. CAN extension included.
ON: Type 5 ignition is available on the trailer package connector (black, 13-pin connector, pin #8, pink), located to the left of the steering column.

FTI-CDP1 

  • Installation and Configuration
  • Notes TOREQUIRED CONNECTION
  • (OBD-II CAN) NOT REQUIRED (CAN extension)
  • OFFLINE CONNECTION REQUIRED (IGN)myFirstech-DL-CH12-Cherokee-TIP-Start-fig- (1)myFirstech-DL-CH12-Cherokee-TIP-Start-fig- (2)

FTI-CDP1 – DL-CH12 – Type 5 2014-18
Jeep Cherokee TIP Start

myFirstech-DL-CH12-Cherokee-TIP-Start-fig- (3)

  • LED programming error codes Module
  • LED flashes RED during programming 1x – CAN error 2x 
  • Key code not learned 3x – No ON 4x
  • Without immobilizer, check CAN/key 5x – VIN error, check
  • CAN wiring 6x – See error 4x 7x
  • KLON error 8x – No ON, check connection

WARNING: READ BEFORE REMOTE STARTING THE VEHICLE

IMPORTANT
All vehicle doors must be closed and locked before the remote start sequence. Failure to comply will result in a remote starter malfunction.

MODULE PROGRAMMING PROCEDURE – TIP-START

myFirstech-DL-CH12-Cherokee-TIP-Start-fig- (2)

TAKE OVER PROCEDURE – TIP-START – TO THE VEHICLE OWNER

NOTE
All vehicle doors must be closed and locked before the remote start sequence.

  1. Press UNLOCK on the after-market remote.myFirstech-DL-CH12-Cherokee-TIP-Start-fig- (5)
  2. TIME RESTRICTIN Within 45 SECONDS from the previous step: Open vehicle door. Enter vehicle. Close the vehicle door.myFirstech-DL-CH12-Cherokee-TIP-Start-fig- (6)
  3. Insert key into the ignition. Turn the key to the ON position. Press and release the BRAKE pedal.myFirstech-DL-CH12-Cherokee-TIP-Start-fig- (7)
  4. Take-over procedure completed. Failure to follow the procedure within the time restriction will result in vehicle engine shutdown.

Documents / Resources

myFirstech DL-CH12 Cherokee TIP Start [pdf] Instruction Manual
FTI-CDP1-CH12, DL-CH12, DL-CH12 Cherokee TIP Start, DL-CH12, Cherokee TIP Start, TIP Start, Start

References

Leave a comment

Your email address will not be published. Required fields are marked *