myFirstech DL-CH12 Cherokee TIP Start
FTI-CDP1 – DL-CH12 – Type 5 2014-18 Jeep Cherokee TIP Start
FIRMWARE
This installation requires the BLADE-AL (DL)-CH12 firmware, the flash module, and the firmware update of the driver before installation.
FACILITY
Type 5 vehicles use CAN connections in the harness at the OBD-II connector, the connection cable is not required. CAN extension included.
ON: Type 5 ignition is available on the trailer package connector (black, 13-pin connector, pin #8, pink), located to the left of the steering column.
FTI-CDP1
- Installation and Configuration
- Notes TOREQUIRED CONNECTION
- (OBD-II CAN) NOT REQUIRED (CAN extension)
- OFFLINE CONNECTION REQUIRED (IGN)
FTI-CDP1 – DL-CH12 – Type 5 2014-18
Jeep Cherokee TIP Start
- LED programming error codes Module
- LED flashes RED during programming 1x – CAN error 2x
- Key code not learned 3x – No ON 4x
- Without immobilizer, check CAN/key 5x – VIN error, check
- CAN wiring 6x – See error 4x 7x
- KLON error 8x – No ON, check connection
WARNING: READ BEFORE REMOTE STARTING THE VEHICLE
IMPORTANT
All vehicle doors must be closed and locked before the remote start sequence. Failure to comply will result in a remote starter malfunction.
MODULE PROGRAMMING PROCEDURE – TIP-START
TAKE OVER PROCEDURE – TIP-START – TO THE VEHICLE OWNER
NOTE
All vehicle doors must be closed and locked before the remote start sequence.
- Press UNLOCK on the after-market remote.
- TIME RESTRICTIN Within 45 SECONDS from the previous step: Open vehicle door. Enter vehicle. Close the vehicle door.
- Insert key into the ignition. Turn the key to the ON position. Press and release the BRAKE pedal.
- Take-over procedure completed. Failure to follow the procedure within the time restriction will result in vehicle engine shutdown.
Documents / Resources
![]() |
myFirstech DL-CH12 Cherokee TIP Start [pdf] Instruction Manual FTI-CDP1-CH12, DL-CH12, DL-CH12 Cherokee TIP Start, DL-CH12, Cherokee TIP Start, TIP Start, Start |