K-SIG
BY LOBIBO

6 CHANNEL WIRELESS
TRANSMITTER & RECEIVE

APRIL 26 2022
Introducing the newest line of products by LobiBox.
Chris Pryor – Technical Specialist

TRANSMITTER – 6-CHANNEL WIRELESS

Part #: KSIG-WLS-TX

1. Addressable Dip Switch: Set the Receiver to the same address
2.  Inputs: Dry contact ONLY
3. Input Power: 12VDC to 24VDC
4. Line of Sight: 300 yards
   a. One mile (with extended range antenna)
5. Frequency: 433Mhz

** Do not place in metal containers unless antenna protrudes *

TRANSMITTER COMPONENT

1. Power
   a. Power IN +
   b. Power IN –
2. Antenna
   a. U.FL connector
3. Output from your device (IN 1 – IN 6)
   a. Motion, Beam, Switch, etc.
4. Input Trigger Test Button
5. Reset Button
6. Addressable Dip Switch

RECEIVER – 6-CHANNEL WIRELESS

Part #: KSIG-WLS-RX6

1. Addressable Dip Switch: Set Transmitter to the same address
2. Outputs: Contact Rating – 250VAC 10A/28VDC 10A
   a. Form C Relays (Common, Normally Open, Normally Closed)
3. Input Power: 12VDC to 24VDC
4. Line of Sight: 300 yards
   a. One mile (with extended range antenna)
5. Frequency: 433Mhz

** Do not place in metal containers unless antenna protrudes **

RECEIVER COMPONENTS

1. Power
   a. Power IN +
   b. Power IN –
2. Antenna
   a. U.FL connector
3. Form C Relays (RLY 1 – RLY 6)
   a. Common (C)
   b. Normally Close (NC)
   c. Normally Open (NO)
4.  Reset Button
5. Addressable Dip Switch

ANTENNA COMPONENTS (OPTIONAL)

3dbi Antenna Kit
Part #: KSIG-ANT-3DBI

• (2) U.FL to Female SMA Cable
•  Cable Length: 14cm
•  (2) 3dbi Antenna
•  300-500m line of sight

10dbi Antenna Kit
Part #: KSIG-ANT-10DBI

• (2) U.FL to Female SMA Cable
• Cable Length: 300cm
• (2) 10dbi Antenna
• 500-900m line of sight

USE CASE 1

• Control Panel
  o Transmitter will send a signal to Receiver 1
• Use the push button to open North Gate.
•  Use on/off switch for Closed Sign.
  o Transmitter will send a signal to Receiver 2.
•  Use the push button to open the Dock Door.

USE CASE 2

•  Gate (East & West)
  o Gates connected to camera or intercom system.
  o Gates connected to Push buttons from Transmitter.
  o, Push buttons (Transmitter) will send a signal to the Receiver to open the gate.
•  Doors (NW, SW, NE, SE)
  o Door Transmitters connected to door contact.
  o Transmitter will send a signal to Indicator Panel connected to the Receiver that the door is open.
• Docks (East & West)
  o Dock Transmitters connected to a motion sensor.
  o Motion sensor (Transmitter) will send a signal to Indicator Panel connected to Receiver
  o Docks connected to Push buttons from Transmitter.
  o, Push buttons (Transmitter) will send a signal to the Receiver to open the door.

Documents / Resources

LobiBox K-SIG 6 Channel Wireless Transmitter and Receiver [pdf] User Guide KSIG-WLS-TX6, K-SIG, 6 Channel Wireless Transmitter and Receiver, K-SIG 6 Channel Wireless Transmitter and Receiver

References

• User Manual