LANCOM LX-6500 Indoor Access Points User Guide
LANCOM LX-6500 Indoor Access Points
Hardware Quick Reference
LANCOM LX-6500
LANCOM LX-6500E
- Serial interface
You can optionally configure the device by connecting it to a PC with a configuration cable (separately available).
- Reset button Pressed up to 5 seconds: device restart
Pressed longer than 5 seconds: configuration reset and device restart - Power
In case the power supply of the device should not be done via the PoE interface, please use only the optionally available plug-in power supply.
- Ethernet interfaces
Use the cable with the Ethernet connectors to connect interface ETH1 (PoE) or ETH2 to your PC or a LAN switch.
- USB interface
Connect compatible USB devices either directly to the USB interface, or use a suitable USB cable
Before initial startup, please make sure to take notice of the information regarding the intended use in the enclosed installation guide!
Operate the device only with a professionally installed power supply at a nearby power socket that is freely accessible at all times.
Please observe the following when setting up the device
→ The power plug of the device must be freely accessible.
→ Do not rest any objects on top of the device.
→ Keep all ventilation slots on the side of the device clear of obstruction.
→ Lockable wall and ceiling mounting with the supplied LANCOM Wall Mount LX-6500
→ Please note that support service for third-party accessories is excluded.
Read More About This Manual & Download PDF:
Documents / Resources
 |
LANCOM LX-6500 Indoor Access Points [pdf] User Guide LX-6500, LX-6500E, Indoor Access Points, LX-6500 Indoor Access Points, Access Points |
