MONKEY-LOGO

MONKEY LOOP ML-DT1 Distortion Effect Pedal for Guitar

MONKEY-LOOP-ML-DT1-Distortion-Effect-Pedal-for-Guitar-PRODUCT-IMAGE

Product Information

Specifications:

  • Product Name: Monkey Loop ML-DT1
  • AC/DC Adapter Jack: Use only specified AC adapter, and connect it to an AC outlet of the correct voltage.
  • Level Knob: Adjusts the level of the effect sounds.
  • Tone Knob: Controls the tone. Rotating counterclockwise makes the sound milder, while clockwise makes it sharper.
  • Input Jack: Accepts signals from a guitar or other effect pedals.
  • Gain Knob: Adjusts the amount of distortion. Clockwise increases the effect, counterclockwise reduces it.
  • Output Jack: Connect to your amp or another effect pedal’s input.
  • Pedal Switch: Turns the effect ON/OFF.
  • Indicator: Shows whether the effect is ON or OFF.

Product Usage Instructions

  1. Power Connection:
    Use the specified AC adapter to connect to the AC/DC Adapter Jack and plug it into a suitable power outlet.
  2. Setting Controls:
    • Adjust the Level Knob to set the desired volume of the effect sounds.
    • Use the Tone Knob to control the tone. Rotate it to make the sound either milder or sharper.
    • Turn the Gain Knob to adjust the amount of distortion, increasing it by rotating clockwise and reducing it by rotating counterclockwise.
  3.  Connecting to Equipment
    • Plug your guitar or other effect pedals into the Input Jack.
    • Connect the Output Jack to your amplifier or another effect pedal’s input.
  4. Activating and Deactivating:
    • Use the Pedal Switch to turn the effect ON or OFF.
    • The Indicator will show whether the effect is currently active or not.

FAQ (Frequently Asked Questions)

  • Q: Can I use any AC adapter with Monkey Loop ML-DT1?
    A: No, only use the specified AC adapter to ensure proper functioning and avoid damage to the product.
  • Q: How do I know if the effect is activated?
    A: The Indicator will show whether the effect is ON (activated) or OFF (deactivated).

USER’S MANUAL

SPECIFICATIONS

  • Input Impedance: 500 kohm
  • Output Impedance: 150 ohm
  • Recommended Load Impedance: 10 kohm
  • Equival Input Noise: -90 dBu or less
  • Current Draw: 5.5 mA (DC 9V)
  • Dimension: 94mm×42mm×48mm
  • Weight: 133g
  • Accessory: Owner’s Manual, Velcro tape1 pair

OVERVEIW

MONKEY-LOOP-ML-DT1-Distortion-Effect-Pedal-for-Guitar- (1) MONKEY-LOOP-ML-DT1-Distortion-Effect-Pedal-for-Guitar- (2)

Documents / Resources

MONKEY LOOP ML-DT1 Distortion Effect Pedal for Guitar [pdf] User Manual
ML-DT1 Distortion Effect Pedal for Guitar, ML-DT1, Distortion Effect Pedal for Guitar, Effect Pedal for Guitar, Pedal for Guitar, Guitar, Pedal

References

Leave a comment

Your email address will not be published. Required fields are marked *