iBoard IB-228C Running Board Side Step Bars
INTRODUCTION
READ INSTRUCTIONS CAREFULLY BEFORE START ING INSTALLATION. REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS RECOMMENDED
*ROCKER PANEL MOUNT
*NO DRILLING REQUIRED
Fastener Size | Tightening Torque (ft-lbs) | Required |
6mm | 6-7 | X |
8mm | 16-18 | √ |
10mm | 31-32 | X |
12mm | 56-58 | X |
14mm | 92-94 | X |
PART LIST
Mounting Bracket List | ||||
Description | Item | QTY | Description | |
Driver Front/Center/Rear Mounting Brackets | 2# | 3 | Passenger Front/Center/Rear Mounting Brackets |
Hardware Package A (For Bracket Installation) | ||||
Description | Item | QTY | Description | |
M8 Large Flat Washers | 2# | 12 | M8X1.25 Nylon Lock Nuts | |
![]() |
Hardware Package B (For Stainless Steel Step Bar Installation) | ||
Description | Item | |
M8X1.25-35mm Carriage Bolts | 3# | |
M8 Large Flat Washers | 4# | |
![]() |
STEP 1
Start installation from the driver side front of the vehicle. Locate the (2) factory threaded studs located on the side of the inner body panel, (Fig 1).
(Fig 1) Driver Side Front Mounting Location
STEP 2
Select the Driver Front Mounting Bracket. Attach to the (2) factory threaded studs with (2) M8 Large Flat Washers and (2) M8X1.25 Nylon Lock Nuts, (Fig 2). Do not fully tighten hardware at this time.
(Fig 2) Driver Side Front Mounting Bracket Installation
STEP 3
Move to the center & rear mounting location. Repeat Steps 1 – 2 for Driver Center & Rear Mounting Brackets.
Note: All (3) Driver Side Mounting Brackets are universal.
STEP 4
Once all (3) Driver side mounting brackets are installed, then proceed to the Step Bar installation. (Figs 3 & 4)
- Select (1) Slider and (2) M8X1.25-35mm Carriage Bolts;
- Install (2) M8X1.25-35mm Carriage Bolts in (1) Slider.
- Slide the Slider (with carriage bolts) to the Step Bar.
- Repeat to install the other (2) sliders to the step bar.
- Attach the Step Bar (with the Sliders) onto the installed mounting brackets. Position the Sliders to the installed brackets. Secure the Step Bar to the installed Brackets by using (6) M8 Large Flat Washers and (6) M8 Nylon Lock Nuts and (3) Sliders, (Fig 4). Do not fully tighten hardware at this time.
Note: The Sliders are packed with the Step Bars.
Level and adjust the Step Bar and fully tighten all hardware. Repeat Steps 1-4 for the other side Step Bar installation. The installation is completed!!!
NOTE: All (3) Passenger Side Mounting Brackets are universal.
Attention
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
In order to protect your bars/boards, please use mild soap/non-abrasive products for cleaning only
(Fig 3) Slider Installation
(Fig 4) Step Bar Installation
Customer Support
Documents / Resources
![]() |
iBoard IB-228C Running Board Side Step Bars [pdf] Installation Guide IB-228C, IB-228H, IB-228C Running Board Side Step Bars, Running Board Side Step Bars, Board Side Step Bars, Side Step Bars, Bars |