ការណែនាំអំពីការដំឡើង
Multi Ejector (Spareparts)
Type CTM 1, CTM 2, CTM 6

 CTM 1 Series Multi Ejector and Strainer

សេវាកម្មនៅលើ strainer

Service on connectors

1. Remove connectors with O-rings
2. Replace O-rings and place new connectors
3. Mount new connectors with screws:
   – 6 mm screws torque: 10 Nm ± 1 Nm
   – 8 mm screws torque: 27.5 Nm ± 2.5 Nm

លំដាប់រឹតបន្តឹង

ឯកសារ/ធនធាន

Danfoss CTM 1 Series Multi Ejector and Strainer [pdf] ការណែនាំអំពីការដំឡើង CTM 1, CTM 2, CTM 6, CTM 1 Series Multi Ejector and Strainer, CTM 1 Series, Multi Ejector and Strainer, Ejector and Strainer, Strainer

ឯកសារយោង

• សៀវភៅណែនាំអ្នកប្រើប្រាស់