KILOVIEW RU-01 4-Channel Rackmount Codec Encoder Frame
Before using this product, it is recommended that you read the guide carefully. To ensure your personal safety and avoid physical or electrical damage to the device, please strictly follow the instructions of this guide to install and use it under the guidance of professionals. Incorrect electrical connections or physical installation may cause permanent damage to the device and even threaten personal safety.
Packing List 
Interface description 
LED light
PWR1 and PWR2 respectively correspond to two power status indicators, and four card indicators display four card working states.
| Name | Status | Description |
|
PWR1/PWR2 power light |
OFF | No power supplied or device failure |
| Red light always on | Working | |
|
Card working light |
OFF |
Not enabled, not insert the card or the card works abnormally |
|
Green light always on |
The card is working |
Power components
Power specifications: 35w power module components 
Power components installation and removal
Align the power components with the card slots and push in parallel, then tighten the double-sided screws. Reverse the process for removal. 
Note: The two power components work uninterrupted at the same time. When one of the components is powered off or damaged, the device will not be powered off. The other one will replace it quickly.
Card installation and removal
Align the card assembly with the card slots and push in parallel, then tighten the double-sided screws. Reverse the process for removal. 
Documents / Resources
 |
KILOVIEW RU-01 4-Channel Rackmount Codec Encoder Frame [pdf] User Guide RU-01 4-Channel Rackmount Codec Encoder Frame, RU-01, 4-Channel Rackmount Codec Encoder Frame |
