ILLUXTRON Sensor Downlight Sensor Vector 100
SYMBOL EXPLANATION
CE The lighting fitting – as well as all other products from the collection – is designed, produced
If in doubt, consult a qualified electrician or contact your retail outlet.
Ensure that you always install the fitting to the relevant regulations
Protection class I: the fitting has an earthing connection. The earth wire (yellow/green) has to be connected to the clip marked with .
Protection class II: the fitting is double insulated and must not be connected to an Earth.
Protection class III: the fitting is only suitable for very low voltage supply.
This fitting should only be installed indoors.
ENERGY CLASS
These products contains a light source of energy efficiency class:
F (3000K) / E (4000K)
Disposal of your old product: Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. Please inform yourself about the local separate collection system for electrical and electronic products.
The fitting may be covered with insulating material.
DETECTION AREA
Sensor luminaires turn on for 4 minutes after detecting movement.
FIXATION DIMENSIONS INSTALLATION
DIMENSIONS
Hole size / Springs
CS (concrete) and WS (wire) springs
CS (concrete) springs
WS (wire) springs
Mercuriusweg 19
4382 NC Vlissingen
The Netherlands
info@illuxtron.com
+31 (0)85 773 63 60
www.illuxtron.com
Documents / Resources
 |
ILLUXTRON Sensor Downlight Sensor Vector 100 [pdf] Owner's Manual Sensor Downlight Sensor Vector 100, Downlight Sensor Vector 100, Sensor Vector 100, Vector 100, 100 |
