M5 STACK Flow Connect Software
MỤTA
Njikọ Flow bụ ihe njikwa ụlọ ọrụ agbakwunyere nke ukwuu emebere maka akpaaka siri ike na gburugburu nzikọrịta ozi. Ọ na-egosipụta ESP32-S3R8 microcontroller na isi ya, nke nwere ihe nrụpụta dual-core Xtensa LX7 na-agba ọsọ ruo 240MHz, ma gụnye 8MB PSRAM na 16MB FLASH ebe nchekwa, nke nwere ike ijikwa mgbakọ na-arụ ọrụ dị elu na mkpa multitasking. Maka nchekwa, ọ na-eji 128Mbit (16MB) 3.3V NOR flash, na-eme ka ogologo oge, arụ ọrụ kwụsiri ike maka firmware, data na nhazi. file nchekwa.
Onye njikwa ahụ na-akwado ọtụtụ usoro nkwukọrịta, gụnyere ụgbọ ala CAN dual, RS232, RS485, na TTL, na-eme ka ọ dabara maka ọtụtụ ngwa ụlọ ọrụ na ngwa IoT. Iji welie mmekọrịta onye ọrụ, Njikọ Flow na-ejikọta Neopixel RGB njikwa ọkụ ọkụ, na-eme ka agba dị ike na mmetụta ọkụ maka nzaghachi anya n'echiche.
Na mgbakwunye, sistemụ njikwa ike Flow Connect na-eji ọtụtụ ndị ntụgharị DC-DC na-akwado volta dị iche ichetage si na 12V ruo 3.3V. Ọ nwekwara atụmatụ arụnyere na fiusi eletrọnịkị (eFuse) iji chekwa voltage ọwa site na-agafe agafe, na-ahụ na ọrụ adịghị mma ọbụna na gburugburu ebe ọjọọ.
Emebere Flow Connect na ihe achọrọ nke njikwa ụlọ ọrụ, ụgbọ njem nwere ọgụgụ isi, na ngwa ọnụ ụzọ IoT n'uche, na-enye nkwurịta okwu multiprotocol ntụkwasị obi, nchekwa data siri ike, ngosipụta RGB siri ike, yana nchekwa ike zuru oke.
Njikọ iyi
- Ike nzikọrịta ozi:
- Onye njikwa isi: ESP32-S3R8
- Nkwukọrịta ikuku: Wi-Fi (2.4 GHz), ike Bluetooth dị ala (BLE) 5.0
- Ụgbọ ala CAN Dual: Na-akwado oghere ụgbọ ala CAN abụọ maka nkwukọrịta data a pụrụ ịdabere na ya na gburugburu ụlọ ọrụ mmepụta ihe.
- Nkwukọrịta Oghere Usoro: RS232, RS485, na TTL maka nhọrọ nzikọrịta ozi ikuku.
- Ihe nhazi na arụmọrụ:
- Ụdị nhazi: Xtensa LX7 Dual-core (ESP32-S3R8)
- Ike nchekwa: 16MB Flash, 8MB PSRAM
- Ugboro na-arụ ọrụ nhazi: Xtensa® dual-core 32-bit LX7 microprocessor, ruo 240 MHz
- Ngosipụta na ntinye:
- RGB LED: Neopixel RGB LED agbakwunyere maka nzaghachi anya dị ike.
- Ebe nchekwa:
- Flash ma ọ bụ: 128Mbit (16MB), 3.3V maka ngwa ngwa na nchekwa data.
- Njikwa Ike:
- Nkwanye ike: Ndị ntụgharị DC-DC na-akwado mmepụta 12V ruo 3.3V.
- Nchedo: Fiusi eletrọnịkị arụnyere n'ime ya (eFuse) maka nchebe karịrị akarị n'ofe voltage ọwa.
- GPIO pins na interface mmemme:
- Grove Interface: Na-akwado njikọ na mgbasawanye nke I2C sensọ na modul ndị ọzọ.
- Ndị ọzọ:
- Onboard Interface: Ụdị-C interface maka mmemme, ọkọnọ ike na nzikọrịta ozi.
- Akụkụ anụ ahụ: 60*60*15 mm
Nkọwapụta
| Parameter na nkọwapụta | Uru |
| MCU | ESP32-S3R8@ Xtensa dual – isi 32-bit LX7, 240MHz |
| Ike nzikọrịta ozi | Wi-Fi, BLE, ụgbọ ala abụọ CAN, RS232, RS485, TTL |
| Tụkwasịnụ Voltage | 12V ruo 3V DC (site na DC-DC converters) |
| Ike Nchekwa Flash | 16MB Flash |
| Ike Nchekwa PSRAM | 8MB PSRAM |
| Ọ BỤGHỊ Flash | GD25Q128/ W25Q128, 128 Mbi t (16MB), 3. 3V |
| RGB LED | 6 x Neopixel RGB LED maka ọkụ dị ike |
| Interface Mgbasawanye | Grove interface maka ijikọ na ịgbasa ihe mmetụta I2C |
| Okpomọkụ na-arụ ọrụ | 0 Celsius C - 40 Celsius |
| Ugboro Wi-Fi na-arụ ọrụ | 802. lb/ g/ n: 2412 MHz – 2482 MHz |
| Ugboro ọrụ BLE | 2402 MHz - 2480 MHz |
| Onye nrụpụta | Ụgwọ nke ụlọ ọrụ M5Stack Technology Co., Ltd |
Ngwa ngwa ngwa
Tupu ịme usoro a, lelee ederede dị na mgbakwunye ikpeazụ: Ịwụnye Arduino
Bipụta ozi WiFi
- Mepee Arduino IDE (tụ aka
https://docs.m5stack.com/en/arduino/arduino_ide maka ntuziaka nrụnye maka bọọdụ mmepe na ngwanrọ) - Họrọ bọọdụ Module ESP32S3 DEV yana ọdụ ụgbọ mmiri kwekọrọ, wee bulite koodu ahụ
- Mepee ihe nleba anya nsonazụ ka igosipụta WiFi enyochagoro yana ozi ike mgbama
Bipụta ozi BLE
- Mepee Arduino IDE (tụ aka
https://docs.m5stack.com/en/arduino/arduino_ide maka ntuziaka nrụnye maka bọọdụ mmepe na ngwanrọ) - Họrọ bọọdụ Module ESP32S3 DEV yana ọdụ ụgbọ mmiri kwekọrọ, wee bulite koodu ahụ
- Mepee ihe nleba anya n'usoro iji gosi ozi ike mgbama BLE enyochagoro
FCC ịdọ aka ná ntị
Akpachara anya FCC:
Mgbanwe ọ bụla ma ọ bụ mgbanwe ọ bụla nke ndị na-ahụ maka nnabata na-akwadoghị nke ọma nwere ike imebi ikike onye ọrụ iji rụọ ọrụ ahụ.
Ngwaọrụ a na-akwado akụkụ 15 nke Iwu FCC. A na-arụ ọrụ n'okpuru ọnọdụ abụọ a:
- Ngwaọrụ a nwere ike ọ gaghị ebute nnyonye anya na-emerụ ahụ, yana
- Ngwaọrụ a ga-anabatarịrị nnyonye anya ọ bụla enwetara, gụnyere nnyonye anya nwere ike ibute ọrụ na-achọghị.
IHE dị mkpa:
Mara: A nwalere ngwa a wee hụ na ọ dabara na oke maka ngwaọrụ dijitalụ Klas B, dịka akụkụ 15 nke Iwu FCC. Emebere oke ndị a iji nye nchebe ezi uche dị na ya megide nnyonye anya na-emerụ emerụ na ntinye ụlọ.
Akụrụngwa a na-ewepụta, na-eji ma nwee ike ịgbasa ike ugboro redio yana, ọ bụrụ na etinyeghị ya ma jiri ya dịka ntuziaka ahụ siri dị, nwere ike ibute ndabichi na-emerụ ahụ na nkwukọrịta redio. Agbanyeghị, enweghị nkwa na nnyonye anya agaghị eme na otu nrụnye. Ọ bụrụ na akụrụngwa a na-ebute nnyonye anya na-emerụ ahụ na nnabata redio ma ọ bụ telivishọn, nke enwere ike ikpebi site na ịgbanyụ ma gbanye akụrụngwa, a na-agba onye ọrụ ume ka ọ nwaa idozi nnyonye anya site na otu ma ọ bụ karịa n'ime usoro ndị a:
- Megharịa ma ọ bụ bugharịa antenna nnata.
- Mee ka nkewa dị n'etiti akụrụngwa na nnata.
- Jikọọ akụrụngwa n'ime oghere na sekit dị iche na nke ejikọrọ onye nnata.
- Kpọtụrụ onye na-ere ahịa ma ọ bụ onye ọrụ redio/TV nwere ahụmahụ maka enyemaka.
Ngwa a na-akwado oke ikpughe radieshon FCC nke edobere maka gburugburu ebe anaghị achịkwa ya. Ekwesịrị ịwụnye akụrụngwa a ma rụọ ọrụ ya na opekempe 20cm n'etiti radiator na ahụ gị.
Wụnye Arduino
- Ịwụnye Arduino IDE(https://www.arduino.cc/en/Main/Software) Pịa ileta onye ọrụ Arduino websaịtị , wee họrọ ngwungwu nwụnye maka sistemụ arụmọrụ gị ibudata.
- Ịwụnye Arduino Board Management
- Onye njikwa Board URL a na-eji iji depụta ozi bọọdụ mmepe maka otu ikpo okwu. Na Arduino IDE menu, họrọ File -> Mmasị
- Detuo njikwa bọọdụ ESP URL n'okpuru n'ime Mgbakwunye Board Manager URLs: ubi, ma chekwaa.
https://espressif.github.io/arduino-esp32/package_esp32_dev_index.json
- Na sidebar, họrọ Board Manager, chọọ M5Stack, wee pịa Wụnye.
- Na sidebar, họrọ Board Manager, chọọ M5Stack, wee pịa Wụnye.
Dabere na ngwaahịa ejiri, họrọ bọọdụ mmepe kwekọrọ n'okpuru Ngwaọrụ -> Board -> M5Stack -> {ESP32S3 DEV Moduleboard}.
- Jikọọ ngwaọrụ gị na kọmputa na a data USB bulite mmemme
Akwụkwọ / akụrụngwa
 |
M5 STACK Flow Connect Software [pdf] Ntuziaka onye ọrụ M5FCV1, 2AN3WM5FCV1, Flow Connect Software, Connect Software, Software |
