Contents
hide
HIOS CLC Series DC Screwdrivers Controller Instruction Manual
Important Safety Instructions
Before using this machine, read this section and follow the instructions to properly use this machine.
Installation
- The unit should be used in a temperature and humidity-controlled room. Keep the unit away from a place with poor ventilation, in dust or metal pieces.
- Do not place any objects on the
- The place to install the unit should be vibration-free and the unit should be securely fixed. If theunit is installed on the wall or on a high place, make sure to use the attached Mounting Bracket to fix it securely.
- Donotinstall the unit close to high voltage
Handling
- Installaleakage breaker and safety breaker on the input power source and connect the ground to use the
- Connect to a power source of the specified
- Do not use with other drivers or devices except the models listed in this operation
- If the protection circuit works due to overheat, stop operation immediately, pull the power plugfrom the outlet and send it back to your HIOS distributor for repair.
- The unit may automatically stop in use when the protection circuit works due to overcurrent, Turn off the power switch once and turn it on in 5 seconds for restart.f the unit stops while in screw fastening, make sure to check the torque of the fastened screw.
- Do not disassemble or modify the
- Donotdrop the power Supply or subject it to violent
- Do not drag the unit by its driver cord or AC Keep the cords away from foreign objects, oil orsomething sharp.
- Makesureto grasp the plug section to disconnect the AC cord from the
- Turn the unit off and disconnect the AC cord from the outlet when the unit is not in
- IMPORTANT SAFETY INSTRUCTIONS-SAVE THESE
- DANGER-TOREDUCE THE RISK OF FIRE OR ELECTRIC CAREFULLY FOLLOW THESE
INSTRUCTIONS.
Accessories
- Power Indicator: Lights up when the power switch is turned ON.
- Connector for the Screwdriver: Connect the screwdriver cord.
- DC Output Switch: 2 (HI: DC30V) / 1 (LOW: DC20V)
- Power Switch: Turns the power ON or
- Connector for AC Cord: Connect the power
Compatible Screwdrivers (Including OPC/SS Type
CLC-45
Series Model
| CL | CL-2000/CL-3000/CL-4000/CL-6000/CL-6500 |
| SS | SS-2000/SS-3000/SS-4000/SS-6500 |
| α | α-4500/α-5000 |
CLC-60
Series Model
| CL | CL-2000/CL-3000/CL-4000/CL-6000/CL-6500/CL-7000 |
| SS
α |
SS-2000/SS-3000/SS-4000/SS-6500/SS-7000 |
| α-4500/α-5000/α-6500 |
CLC-80
Series Model
| CL | CL-9000NL |
Attach the Mounting Bracket
Specifications
HIOS Inc.
1-35-1 Oshiage, Sumida-ku Tokyo, Japan
Read More About This Manual & Download PDF:
Documents / Resources
 |
HIOS CLC Series DC Screwdrivers Controller [pdf] Instruction Manual CLC-45, CLC-60, CLC-80, CLC Series DC Screwdrivers Controller, CLC Series, DC Screwdrivers Controller, Screwdrivers Controller, Controller |