Hewei Electronic Technology HW58S3-XYLS Multi-Protocol Card Reader Module ka palapala a ka mea nona.

Huahana Huahana

inoa: Multi-protocol Card Reader Module（SPI）
Hoʻohālike: HW58S3-XYLS
Code: 5824080801

Hoʻololi moʻolelo:

Lā	Manao	Hoʻomākaukau	Hoʻopaʻa ʻia	Hoʻololi maʻiʻo	ʻŌlelo
2024/08/08	V1.0	Xu Xiaobing	Wang Handing	Kakau mua

Kiʻi Huahana:

ʻO ka wehewehe ʻana o ka pilina (12-pin stamp puka, SPI)

Pin1	Pin2	Pin3	Pin4	Pin5	Pin6	Pin7	Pin8	Pin9, 10,11,12
NSS	SCLK	MOSI	MISO	IRQ	GND	RST	VCC	NC

Nui Huahana (mm)

Huahana Pauview

• ʻO kēia module he 13.56MHz kāleka heluhelu a kākau ʻana i kūkulu ʻia ma muli o ka chip heluhelu kāleka MH1612;
• ʻAha voltage pae hana, voltage 2.0-5.5V;
• Support ISO/IEC 14443 Type A/Type B protocol;
• Supports ISO/IEC 18092 protocol;
• Supports ISO/IEC 15693 protocol;
• Kākoʻo i nā noi uku kelepona e like me Apple Pay a me Samsung Pay;
• Kākoʻo i ka palapala hōʻoia EMV3.0/3.1, me nā hoʻāʻo hōʻoia hōʻoia pili uila, ka protocol, a me ka mobile;
• SPI, rate up to 10Mbit/s;
• Support low power card detection function (LPCD);
• The main MCU consumes less resources and can support multiple cores;
• Integrated PCB antenna, can simply achieve stable and reliable non-contact card operation;

Nā Kūlana Huahana

inoa	Multi-protocol Card Reader Module（SPI）
Hoʻohālike	HW58S3-XYLS
Nui	Length * width * height 40*40*4mm
Kaiapuni	Mahana: -40-85℃ Ka haʻahaʻa: 5%~95% no condensation and ice
Kāleka Pili ʻole	Supports 14443 Type A/Type B contactless smart card Supports Feilica card and ISO15693 card
Ka mamao heluhelu kāleka	≤5cm
ʻano kamaʻilio	SPI, a hiki i 10Mbit/s
Ka mana	Supports 2.0-5.5V input (DC3.3V)
Hoʻopuehu	Typical working current 120-200mA (DC3.3V)
lako polokalamu	Refer to the latest MH1612 data sheet for detailed module operation timing and instructions
Nānā	The product needs to be installed away from metal environments (≥4cm), otherwise it may interfere with the card reading signal and shorten the reading distance. If this occurs, try attaching ferrite absorbing paper to the back of the card reader. If the card still cannot be read, please contact technical support.

Conformal coating follows the following standards:

1. Spray coating thickness: 0.1-0.3 mm, with a cured thickness of 40-60 µm.
2. Conformal coating bubble standards: Bubbles are allowed on the plastic body or insulating parts of components, and small bubbles within the coating are acceptable. Only a single bubble enclosing a single part of a conductor is acceptable; bubbles between the component leads are not acceptable.
3. ʻAʻole pono e uhi ʻia ke keleawe i hōʻike ʻia me ka uhi ʻana, nā mea hoʻohui, a me nā mea mana me ka uhi conformal.
4. ʻAʻole pono nā ʻāpana i loko o 3 mm a puni nā mea hoʻohui i ka uhi kūlike, akā pono e loaʻa kahi ʻāpana kaʻawale o ka uhi conformal a puni nā mea hoʻohui.
5. ʻAʻole ʻae ʻia ka uhi conformal i loko o 5 mm anawaena o nā puka hoʻonohonoho, ʻaʻole pono e hoʻopiha ʻia nā puka.
6. Pono e uhi ʻia nā alakaʻi ʻāpana IC a pau me ka uhi conformal, a e ʻike ʻia ke ʻano o ka uhi conformal ma ke kino.

Salt Spray Testing is conducted in accordance with the following standards:

GB/T 2423. 17-2008 《Environmental Testing for Electrical and Electronic Products, Mahele 2: Hoao
Methods, Test Ka: Salt Spray》

ʻŌlelo FCC
Hoʻopili kēia mea hana i ka Māhele 15 o nā lula FCC.
Aia ka hana i nā kūlana ʻelua:

1. ʻAʻole hiki i kēia mea hana ke hoʻopilikia ʻino, a
2. pono e ʻae kēia hāmeʻa i nā hoʻopilikia i loaʻa, me ka hoʻopili ʻana i hiki ke hoʻokō i ka hana makemake ʻole.

Nānā: Ua hoʻāʻo ʻia kēia mea hana a ua ʻike ʻia e hoʻokō i nā palena no kahi hāmeʻa kikohoʻe Papa B, e like me ka ʻāpana 15 o nā Rula FCC. Hoʻolālā ʻia kēia mau palena no ka hāʻawi ʻana i ka palekana kūpono mai ka hoʻopilikia ʻino ʻana i kahi hoʻonohonoho hale. Hoʻohana kēia mea hana i nā hoʻohana a hiki ke hoʻomālamalama i ka ikehu alapine lekiō a, inā ʻaʻole i hoʻokomo ʻia a hoʻohana ʻia e like me nā kuhikuhi, hiki ke hoʻopilikia i nā kamaʻilio lekiō.
Eia nō naʻe, ʻaʻohe mea e hōʻoiaʻiʻo ʻaʻole hiki ke keakea i kahi hoʻonohonoho kūikawā. Inā hoʻopilikia kēia mau mea hana i ka lekiō a i ʻole ke kīwī, hiki ke hoʻoholo ʻia ma ka hoʻopau ʻana i nā mea hana, paipai ʻia ka mea hoʻohana e hoʻoponopono i ka hoʻopili ʻana ma o hoʻokahi a ʻoi aku paha o kēia mau ana:

• Hoʻonohonoho hou a hoʻoneʻe paha i ka antenna e loaʻa ana.
• E hoʻonui i ka kaʻawale ma waena o nā mea hana a me ka mea hoʻokipa.
• E hoʻohui i nā mea hana i kahi puka ma kahi kaapuni ʻokoʻa mai ka mea i hoʻopili ʻia ai ka mea hoʻokipa.
• E kūkākūkā i ka mea kūʻai aku a i ʻole kekahi mea loea lekiō/TV no ke kōkua.

ʻO nā hoʻololi a i ʻole nā ​​hoʻololi i ʻae ʻole ʻia e ka ʻaoʻao kuleana no ka hoʻokō hiki ke hoʻopau i ka mana o ka mea hoʻohana e hana i nā lako.

Hōʻike Hōʻike Hōʻikeʻike FCC
Hoʻopili kēia hāmeʻa i nā palena hōʻike radiation FCC RF i hoʻonohonoho ʻia no kahi kaiapuni ʻole. ʻAʻole pono e hoʻopili ʻia kēia transmitter a i ʻole e hana pū me kekahi antenna a i ʻole transmitter.
Pono e hoʻohana i kēia hāmeʻa me kahi mamao loa o 20 knm ma waena o ka radiator a me ka mea hoʻohana.

Palapala / Punawai

Hewei Electronic Technology HW58S3-XYLS Multi-Protocol Card Reader Module [pdf] Palapala a ka mea nona HW58S3-XYLS, HW58S3-XYLS Multi-Protocol Card Reader Module, Multi-Protocol Card Reader Module, Card Reader Module, Reader Module, Module

Nā kuhikuhi

• Palapala Hoʻohana