Harvest Nodestream Mini Unit
OVERVIEW
Thank you for choosing Harvest Technology
Please read these instructions carefully before using this product, and save this quick start guide for future use. See the User Manual for full details via the QR code on the back page.
Video and two-way audio streaming solution
In the Box
Nodestream Mini
The Nodestream Mini (NSM) is a video and audio streaming device that can be configured either as an encoder or decoder. Ensure adequate spacing to allow cooling air to travel through vents as shown by the arrows.
Rear Connections
User Interface
START UP
- Power on the device (from mains)
- Device Configuration (if required) Connect a monitor, keyboard/mouse An on screen GUI displays, for further information – see User Manual
- Press and hold VOL button (see next page) or select Launch Nodestream to start software
- NOTE: For encoders only, the software starts automatically if an external monitor is not connected.
Blue PTT LED indicates the software is running. - Refer to the Nodester application for device status and connection management
Typical Boot Sequence
OPERATION
Status LED
(Blue) Power On
(Green) Video Streaming
(Red) No Network
PTT (Push To Talk)
(Off) Software not running
(Blue ) Software running
(Green) Audio connection active, mic muted
(Red) Mic open
VOL (Volume)
Troubleshooting
| Issue | Cause | Resolution |
| Device not powering. | AC or DC not connected. Faulty PSU. | Confirm AC connected to PSU (LED on PSU is illuminated).
Confirm DC connected correctly at rear of device. |
| Video sources not displaying. (When in encoder mode) | Source(s) not connected or powered on. | Confirm video source(s) connected and powered on. |
| No display output. | Video output device not connected or powered on. | Confirm video output device connected and powered on. |
| No network –
“Connecting to Nodestream server 0%” message displayed and status LED is red. |
No connection to server. | Check Ethernet cable or WiFi is connected.
Ensure required firewall ports settings are correct (see User Manual).
Check network settings, contact your network administrator to diagnose network issues. |
Technology Park, 7 Turner Ave, Bentley WA 6102
Australia www.harvest.technology
All rights reserved. This document is the property of Harvest Technology Group. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, photocopy, recording or otherwise without the written consent of the Group Chief Executive
Contact and Support support@harvest-tech.com.au
Documents / Resources
 |
Harvest Nodestream Mini Unit [pdf] User Guide Nodestream Mini Unit |
