ADT Tsaro XPP01 Sensor Button Firgita

Ƙayyadaddun samfur

• Sunan samfur: Sensor Button Tsoro
• Lambar Samfura: XPP01
• Zaɓuɓɓukan hawa: Wristband or Belt Clip
• Tushen wutar lantarki: Batirin Cell

Umarnin Amfani da samfur

Mounting the Panic Button Sensor

1. Take the Panic Button Sensor and attach it to your hand wrist or belt clip.
2. Haɗa Sensor Button Firgici zuwa panel.

Preparing the Panic Button Sensor

Ensure you have the band bracket and belt clip ready for installation.

Adding Panic Button Sensor to the Panel

To add the Panic Button Sensor to your panel, simply press the button on the sensor and follow the panel’s instructions for adding a new device.

Canza Baturi

1. Cire na'urar daga wuyan hannu ko shirin bel.
2. Cire madaidaicin don samun damar sashin baturi.
3. Cire tsohon baturin salula kuma musanya shi da sabon.

Using Your Panic Button Sensor

Add the Panic Button Sensor to your Security Panel. You can wear it on your hand wrist or clip it onto your belt for easy access in case of emergency.

Tambayoyin da ake yawan yi (FAQ):

Tambaya: Ta yaya zan san idan an haɗa Sensor Button Sensor zuwa panel?

• A: Once you have connected the Panic Button Sensor to the panel, you may receive a confirmation message or light indicator on the panel.

Tambaya: Yaya tsawon lokacin batirin tantanin halitta yakan wuce kafin buƙatar sauyawa?

• A: The battery life can vary based on usage, but it is recommended to check and replace the battery annually to ensure optimal performance.

Sensor Button Tsoro

• The Panic Button Sensor (XPP01) is designed for emergency calls to a monitoring center.
• It communicates with the XP02 Control Panel via 433 MHz frequency.

The Panic button Sensor

Your Panic button Sensor has two key steps:

1. Take the Panic button sensor on the hand wrist or belt clip.
2. Connect the Panic button sensor to the panel.

Shirya Maɓallin Firgita Sensor

Add a Panic Button Sensor to your panel

Getting your Panic button Sensor up and running is as simple as pressing the button, and adding it to the panel.

Canja baturi

Da fatan za a bi tsarin da ke ƙasa.

1. Take the device out from the wristband as below picture.
2. Unscrew the bracket as below picture.
3. Take the device out from the belt clip as below picture.
4. Unscrew the bracket as below picture.
5. Take away the rear cover. Pull out the cell battery as below pictures.
6. Take out the old cell battery and insert a new one as below picture.

Yi amfani da Sensor Button Firgita

• Add your Panic Button Sensor to the Security Panel.
• You can wear the Panic Button on your hand wrist or clip it on your belt.
• Da fatan za a koma ga hoton da ke ƙasa.

Takardu / Albarkatu

ADT Tsaro XPP01 Sensor Button Firgita [pdf] Jagorar mai amfani XPP01 Sensor Button Firgita, XPP01, Maɓallin Maɓallin tsoro, Maɓallin Maɓalli, Sensor

Magana

• Manual mai amfani