Gdrasuya10 QLB15DPS Modern Ceiling Light with Fan Remote Control Instructions
NOTE
The product drawing of the manual may be different from the actual product, and the wiring and installation methods are the same.
Attention:
This appliance is not intended for use by persons(including children)with reduce physical,sensory or mental capabilities,or lack of experience and knowledge,unless they have been given supervision or instruction concer-ning use of the appellant& by a person responsible fur their safety.
STRUCTURE DRWAING
ASSEMBLY INSTRUCTIONS
Installing Hanger bracket Secure the hanger bracket to the ceiling joist or suitable piece of timber inserted between the ceiling joists. The bracket should be attached with two long screws supplied.
Remover the R-pin and Cross pin from downrod.Thread the wires through the downrod, and insert the Downrod into the Couple.
Loose the two setscrews in the downrod support.Return installing the Cross pin and secure with the R-pin.
Carefully lift fan assembly into hanger bracket that is just attached to the outlet box.Be sure the groove in the ball is lined up with tab on the hanger bracket.
After wiring ,attach the canopy to the hanger bracket by pushing up and twisting to locate screws in key holes then tighten screws securely.
TROUBLE SHOOTING
If you have difficulty operating your new ceiling fan,it may be the result of in correct assembly,installation,or wiring. In some cases,these installation errors may be mistaken for defects.If you experience any faults,please check this Trouble Shooting Chart. If a problem cannot be remedied,or you are experiencing difficulty in installation,please call our Customer Service Center at the number prnted on your parts list insert sheet.
Warning :Before servicing or cleanign unit ,Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally.
When the service disconneting means cannot be locked, securely fasten a prominent warning device,such as a tag, to the service panel.
IF FAN DOES NOT START
- Check main and branch circuit fuses or circuit breakers.
- Check line wire connections to fan and switch wire connections in switch housing.
- Check to make sure the dip switches from the trans-mitter and receiver are set on the same frequency.
CAUTION
MAKE SURE MAIN POWER IN TURNED OFF; IF FAN SOUNDS NOISY
- Check to make sure all screws in motor housing are snug(not over tightened).
- Check to make sure the screws which attach the fan blade holder to the motor are tight.
- Check to make sure wire nut connectors in switch housing are not rattling against each other or against the interior wall of the switch housing.
CAUTION: Make sure main power is turned off before entering switch housing. Some fan motors are sensitive to signals from Solid State variable speed controls.
DO NOT USE A SOLID STATE VARIABLE SPEED CONTROL
Allow” break-in” period of 24 hours.Most noises associated with a new fan will disappear after this period.
IF LIGHT DOES NOT WORK
- Check wire fromfan to make sure it is connected to hot wire from house.
- Check for loose or disconnected wires in fan switch housing.
- Check for loose or disconnected wires in light kit.
- Check for faulty light bulbs.
CAUTION:MAKE SURE MAIN POWER IS TURNED OFF BEFOREZENTE-RING SWITCH HOUSING.
WARRANTY CARD
Documents / Resources
 |
Gdrasuya10 QLB15DPS Modern Ceiling Light with Fan Remote Control [pdf] Instructions QLB15DPS, Modern Ceiling Light with Fan Remote Control |
