FIRSTECH FTI-STK1 Crosstrek STD KEY AT Installation Guide

Covered vehicle use BLADE-AL-SUB9 firmware and the following required accessories, Weblink Hub & ACC RFID1. Flash module, and update the controller firmware. Please follow the directions for RFID programming before attempting to program the BLADE module to the vehicle.

CAN: Type 1 CAN connections are made using the 20-Pin BCM adapter and require connecting the white 2-pin connectors at marker [D] of the illustration.
Immobilizer: Type B IMMO requires connecting the black and white 2-pin connectors at marker [C] of the illustration.

Lights: Parking lights are pre-wired in the FTI-STK1 harness. Replace the green/white wire of the CM I/O connector with the pre-terminated green/white wire of the harness.
ACC–RFID1 (REQUIRED): SUB9 firmware does not provide immobilizer data, an ACC-RFID1 is therefore required for remote start

2nd START: The FTI-STK1 harness is pre-wired with a red/black 2nd START output (not required in TYPE 1), cut and insulate the provided wire to prevent short circuits when not used.
I/O Changes: None required

Advisory 1: Program ACC-RFID1 before attempting to program the BLADE module to the vehicle.
Advisory 2: Secure all 2-pin connections, both used and unused, to the main harness body.

FTI-STK1: Installation and Configuration Notes

A. REQUIRED ACCESSORY

B. ADAPTER REQUIRED
C. REQUIRED CONFIGURATION (TYPE B IMMO)

D. NO CONNECTION
E. NO CONNECTION

FEATURE COVERAGE

FTI-STK1 – AL-SUB9 – Type 1 2024 Subaru Crosstrek STD KEY(CA)

LED Programming Error Codes

Module LED flashing RED during programming

1x RED = Unable to communicate with RFID or immobilizer data.

2x RED = No CAN activity. Check the CAN wire connections.
3x RED = No ignition detected. Check the ignition wire connection and CAN.

4x RED = Required ignition output diode not detected.

CARTRIDGE INSTALLATION

Slide cartridge into unit. Notice button under LED.
Ready for Module Programming Procedure.

MODULE PROGRAMMING PROCEDURE

Documents / Resources

	FIRSTECH FTI-STK1 Crosstrek STD KEY AT [pdf] Installation Guide DL-SUB9, CM7000-7200, CM-X, FTI-STK1 Crosstrek STD KEY AT, FTI-STK1, Crosstrek STD KEY AT, STD KEY AT, KEY AT, AT
	FIRSTECH FTI-STK1 Crosstrek STD KEY AT [pdf] Installation Guide Type 4 2018-23, FTI-STK1 Crosstrek STD KEY AT, FTI-STK1, Crosstrek STD KEY AT, STD KEY AT, KEY AT, AT
	FIRSTECH FTI-STK1 Crosstrek STD KEY AT [pdf] Installation Guide Subaru Crosstrek STD KEY AT USA, 2024, FTI-STK1 Crosstrek STD KEY AT, FTI-STK1, Crosstrek STD KEY AT, STD KEY AT, KEY AT, AT
	FIRSTECH FTI-STK1 Crosstrek STD KEY AT [pdf] Installation Guide DL-SUB9, CM7000-7200, CM7X00, FTI-STK1 Crosstrek STD KEY AT, FTI-STK1, Crosstrek STD KEY AT, STD KEY AT, KEY AT, AT
	FIRSTECH FTI-STK1 Crosstrek STD Key AT [pdf] Installation Guide Type 2 2018-23 Subaru Crosstrek STD KEY AT CA, FTI-STK1 Crosstrek STD Key AT, FTI-STK1, Crosstrek STD Key AT, STD Key AT, Key AT, AT
	FIRSTECH FTI-STK1 Crosstrek STD Key AT [pdf] Installation Guide Type 4 2019-24, FTI-STK1 Crosstrek STD Key AT, FTI-STK1, Crosstrek STD Key AT, STD Key AT, Key AT, AT