EPH CONTROLS CDT2-24 Room Thermostat with Delay Start
CAUTION!
Installation and connection should only be carried out by a qualied person and in accordance with national wiring regulations.
- Before commencing any work on the electrical connections, you must rst disconnect the thermostat from the 24Vac supply.
- Ensure the electrical connections are not live until the installation has been completed and the housing is closed.
- Only qualied electricians or authorised service sta are permitted to open the thermostat.
- There are parts that may carry mains voltage behind the cover. The thermostat must not be left unsupervised when open. (Prevent non specialists and especially children from gaining access to it.)
- If the thermostat is used in a way not specied by the manufacturer, its safety may be impaired.
- Prior to setting the thermostat, it is neccessary to complete all required settings described in the section.
INSTALLATION INSTRUCTION
This thermostat can be mounted in the following ways:
- To a recessed conduit box
- To a surface mounted box
- Directly mounted on wall
ABOUT COMPANY
- EPH Controls Ireland
- EPH Controls UK
Documents / Resources
 |
EPH CONTROLS CDT2-24 Room Thermostat with Delay Start [pdf] Instruction Manual CDT2-24 Room Thermostat with Delay Start, CDT2-24, Room Thermostat with Delay Start, Thermostat with Delay Start, Delay Start, Start |
 |
EPH CONTROLS CDT2-24 Room Thermostat with Delay Start [pdf] Instruction Manual CDT2-24 Room Thermostat with Delay Start, CDT2-24, Room Thermostat with Delay Start, Thermostat with Delay Start, Delay Start |
 |
EPH CONTROLS CDT2-24 Room Thermostat with Delay Start [pdf] Installation Guide CDT2-24 Room Thermostat with Delay Start, CDT2-24, CDT2-24 Room Thermostat, Room Thermostat with Delay Start, Room Thermostat, Delay Start Thermostat, Thermostat |
