DDR4 skrivebordshukommelse
“
Produktinformation
Specifikationer:
- Memory Type: DDR4 Desktop Memory (Unbuffered)
- Available Capacities: 16GB (Single Module)
- Available Frequencies: 3200MHz, 3600MHz
- Voltage: 1.2V
- Pinkonfiguration: 288-benet
- Error Correction: Non-ECC Unbuffered
- Registered: Yes
- CAS Latency: CL21 (depending on frequency)
- Form Factor: DIMM (Dual In-line Memory Module)
- Heat Spreader: Aluminum heat spreader
Kompatibilitet:
Compatible with desktop motherboards with DDR4 slots.
Anbefalede komponenter:
Compatible with Intel 600, 500, and 400 series chipsets and AMD
500 and 400 series chipsets. Also works with older chipsets that
support DDR4 memory.
Recommended Processors: Intel Core i3, i5, i7, i9 processors
(10th to 13th Gen) and AMD Ryzen 3, 5, 7, 9 processors (3000 to
5000 series).
Produktbrugsvejledning
Hukommelseskonfiguration:
- Install memory in pairs for dual-channel operation.
- Use identical memory modules with the same capacity and
frequency for best results. - Enable XMP/D.O.C.P. in BIOS to achieve advertised speeds.
Installationsvejledning:
- Sluk for systemet: Sluk computeren
helt og frakobl alle strømkabler fra strømmen
levere. - Open the Computer Case: Fjern sidepanelet
of your computer case to access the motherboard. - Find hukommelsespladser: Identificér hukommelsespladserne
on your motherboard. Consult your motherboard manual for optimal
slot population order. - Udløserklemmer: Åbn opbevaringen
klemmerne i begge ender af hukommelsesstikket ved at skubbe dem udad. - Juster hukommelsesmodulet: Justér hakket i
the memory module with the key in the memory slot for proper
orientering. - Installer hukommelsen: Tryk fast ned på
hukommelsesmodulet, indtil fastholdelsesklipsene klikker på plads
automatisk. - Gentag for yderligere moduler: Hvis du installerer
multiple modules, repeat the process for each module following the
motherboard’s recommended sequence. - Close the System: Replace the computer case
panel, reconnect all cables, and power on the system.
Note: After installation, enter the system
BIOS/UEFI to verify memory detection and enable XMP/D.O.C.P. for
advertised speed.
Ofte stillede spørgsmål (FAQ)
Q: What should I do if my system does not boot after installing
KLLISRE Desktop DDR4 Memory?
A: Ensure that the modules are correctly seated in the memory
slots. Try reseating the modules or testing them one at a time to
identify any faulty module. Check compatibility with your
motherboard and ensure BIOS settings are configured correctly.
Q: Can I mix different capacities or frequencies of KLLISRE
Desktop DDR4 Memory modules?
A: While it is possible, it is recommended to use identical
modules for optimal performance. Mixing capacities or frequencies
may result in compatibility issues or reduced performance.
"`
KLLISRE Desktop DDR4 Memory
Download brugermanual og installationsvejledning som Word-dokument
Produkt overview
KLLISRE Desktop DDR4 Memory modules are designed for high-performance computing, offering excellent speed and reliability for gaming, content creation, and everyday computing tasks. These modules feature sleek heat spreaders for improved thermal performance and stability.
Specifikationer
Specifikation Hukommelsestype Tilgængelig kapacitet Tilgængelige frekvenser Vol.tage Pin Configuration Error Correction Registered CAS Latency Form Factor Heat Spreader
Details DDR4 Desktop Memory (Unbuffered) 16GB (Single Module) 3200MHz, 3600MHz 1.2V 288-pin Non-ECC Unbuffered CL21 (depending on frequency) DIMM (Dual In-line Memory Module) Yes, aluminum heat spreader
Kompatibilitet
Desktop motherboards with DDR4 slots
Kompatible komponenter
Anbefalede bundkort
KLLISRE Desktop DDR4 Memory is compatible with a wide range of desktop motherboards:
Intel 600, 500, and 400 series chipsets (Z690, B660, H610, Z590, B560, etc.)
AMD 500 and 400 series chipsets (X570, B550, X470, B450, etc.) Older chipsets that support DDR4 memory
Anbefalede processorer
This memory works with both Intel and AMD platforms:
Intel Core i3, i5, i7, i9 processors (10th, 11th, 12th, 13th Gen)
AMD Ryzen 3, 5, 7, 9 processors (3000, 4000, 5000 series)
Hukommelseskonfiguration
For optimal ydelse:
Install memory in pairs for dual-channel operation (check motherboard manual for correct slots)
For best results, use identical memory modules with same capacity and frequency
Enable XMP/D.O.C.P. in BIOS to achieve advertised speeds
Note: Higher frequency memory (3600MHz) may require a more recent CPU and motherboard to achieve full speed. Always check your motherboard’s QVL (Qualified Vendor List) for compatibility.
Installationsvejledning
Warning: Always handle memory modules by the edges. Avoid touching the gold contacts or components on the circuit board. Static electricity can damage the memory, so use an anti-static wrist strap when handling components. 1 Power Down the System Shut down the computer completely and disconnect all power cables from the power supply.
2 Open the Computer Case Remove the side panel of your computer case to access the motherboard.
3 Locate Memory Slots Identify the memory slots on your motherboard. Consult your motherboard manual for optimal slot population order (usually slots 2 and 4 for dual channel).
4 Udløs fastholdelsesklips Åbn fastholdelsesklipsene i begge ender af hukommelsesporten ved at skubbe dem udad.
5 Juster hukommelsesmodulet. Juster hakket i hukommelsesmodulet med nøglen i hukommelsesporten for at sikre korrekt retning.
6 Installer hukommelsen Tryk hukommelsesmodulet godt ned, indtil fastholdelsesklipsene automatisk klikker på plads.
7 Gentag for yderligere moduler. Hvis du installerer flere moduler, skal du gentage processen for hvert modul i henhold til bundkortets anbefalede isætningsrækkefølge.
8 Close the System Replace the computer case panel, reconnect all cables, and power on the system.
Note: After installing new memory, enter the system BIOS/UEFI to verify that all memory is detected and enable XMP/D.O.C.P. to achieve the advertised speed.
Fejlfinding
Systemet starter ikke op efter installation
Possible causes: Improperly seated memory, incompatible memory, BIOS needs update.
Solutions: Reseat memory modules, clear CMOS, update motherboard BIOS to latest version.
Kun delvis hukommelse registreret
Mulige årsager: Forkert isat hukommelse, inkompatibel hukommelsesudfyldning, defekt hukommelsesplads.
Løsninger: Genindsæt hukommelsesmodulerne, se bundkortets manual for korrekt rækkefølge, prøv moduler i forskellige slots.
Memory Not Running at Advertised Speed (3200/3600MHz)
Why this happens: By default, DDR4 memory runs at a conservative JEDEC standard speed (usually 2133MHz or 2400MHz). To achieve the advertised higher speeds, you must enable the XMP (Extreme Memory Profile) for Intel systems or D.O.C.P. (Direct Overclock Profile) for AMD systems in the BIOS.
Other reasons: Some older CPUs or motherboards may not support higher memory speeds. The memory controller in your CPU has limitations, and motherboard topology can affect maximum achievable speed.
Løsninger:
1. Enter BIOS/UEFI settings during boot (usually by pressing DEL or F2)
2. Find memory settings (often under “Advanced” or “Overclocking” menu)
3. Enable XMP (Intel) or D.O.C.P. (AMD)
4. Select the appropriate profile for your memory speed
5. Save changes and exit BIOS
6. If system becomes unstable, update BIOS to latest version
7. If problems persist, you may need to manually set speed and timings
Systemustabilitet eller nedbrud
Mulige årsager: Inkompatible hukommelsesindstillinger for timing, overophedning, utilstrækkelig strøm.
Solutions: Load BIOS optimized defaults, ensure proper system cooling, verify power supply adequacy, test with one module at a time.
Blue Screen Errors
Possible causes: Memory compatibility issues,Processor incompatibility, incorrect timings.
Solutions: Test each module individually, run memory diagnostic tools (Windows Memory Diagnostic or MemTest86), adjust BIOS memory settings.
Bemærk: Hvis problemerne fortsætter, skal du teste hvert hukommelsesmodul individuelt for at identificere potentielt defekte moduler. Kontakt KLLISRE-support, hvis du har mistanke om et defekt produkt.
Garantioplysninger
KLLISRE Desktop DDR4 Memory modules are covered by one year warranty. The warranty covers defects in materials and workmanship under normal use. Proof of purchase is required for warranty service.
Ved garantikrav eller teknisk support bedes du kontakte KLLISRE support med dine købsoplysninger og en beskrivelse af problemet.
Denne garanti dækker ikke skader som følge af ulykker, misbrug, forkert installation eller uautoriserede ændringer.
2023 KLLISRE. All rights reserved. KLLISRE is a registered trademark. Specifications are subject to change without notice.
Dokumenter/ressourcer
 |
KLLISRE DDR4 Desktop Memory [pdfBrugermanual 16GB 3200MHz, 16GB 3600MHz, DDR4 Desktop Memory, DDR4, Desktop Memory, Memory |