For BMA CT or CTH

Step 1
Remove adhesive tape liner from bottom three surfaces of conduit box to expose adhesive strips. This adhesive is rated for high temperatures.

Conduit Box Part Number:
910-3200-205-CB
Included Parts:

• Conduit box with 6 concentric 1/2” and 3/4” knockouts, with adhesive strips on edges (1)
• Conduit box lid (1)
• M4x8mm screws (4)

Step 2
To avoid prematurely engaging the adhesive while you align the open end of the box to the BMA CT/CTH connectors, tilt the conduit box and slide it into position against the self clinching nuts. Press the box into place.

Step 3
Remove the conduit box lid.
Attach conduit.
Route cables through desired knockouts.
Use the four M4x8mm screws to re-attach the conduit box lid.

For BMA 360

Step 1
Use the six M3x8mm screws to attach the conduit box to the back of the BMA 360.

Conduit Box Part Number:
910-3200-208-CB
Included Parts:

• Conduit box with 12 concentric 1/2” and 3/4” knockouts
• Conduit box lid (1)
• M4x8mm screws (4)
• M3x8mm screws (6)

Step 2
Remove the conduit box lid.
Attach conduit.
Route cables through desired knockouts.
Use the four M4x8mm screws to re-attach the conduit box lid.

SALES AND INQUIRIES

Headquarters
5225 Wiley Post Way Suite 500 Salt Lake City, UT 84116
US & Canada
Tel: 801.975.7200
Fax: 801.303.5711
International
Tel: +1.801.975.7200
global@clearone.com
Sales
Tel: 801.975.7200
sales@clearone.com
Tech Support
Tel: 801.974.3760
techsupport@clearone.com