AM-W13 INSTRUCTION MANUAL
WIRELESS MICROPHONE
ACCESSORIES
INSTRUCTIONS
- Microphone head Section:
Including Microphone Cover Net and Microphone Cartiridge Module. - Display Screen:
Display working channels, battery power, frequency. - Switch button:
Press for 3 seconds on/off the microphone. - Frequency adjust button.
- POWER BUTTON
- USB CHARGING PORT
- SIGNALANTENNA
- BATTERY INDICATOR
- RF LIGHT
LIGHT INSTUCTION
| Battery indicator® | Turns red and flashes quickly | The power of the receiver is in a low battery status. |
| Stays on | The receiver is in charging model. | |
| Turns off | The receiver is fully charged. | |
| RF light 0 | Flashes slowly | The receiver is not connected to the microphone. |
| Stays on | The receiver and microphone are successfully connected. | |
| Flashes quickly | The receiver and microphone are successfully connected, and the microphone is transmitting audio signals. |
SPECIFICA
Type: Dynamic
Frequency Response: 50Hz-16KHz
Polar Pattern: Cardioid
Output Impedance: 6000
Sensitivity: -52dBt1.5dB
SIN Ratio: 96dB
Input Sample Rate: 48KHz
Bit Rate: 24bit
THD+N: 0.05%
NOTES
 |
When using this device, keep it away from water. |
 |
Use the device in ventilated environment, keep it away from fire. |
 |
Since it’s a wireless device, please keep it away from other I interfering sources. |
 |
Don’t take apart the device. |
 |
Please use the standard power supply, high voltage may damage the device. |
 |
Please place the used batteries into the recycle bin, don’t litter them. |
support@audioarray.in
audioarray.in
/C/AudioArray
@audioarray.in
@audioarray.in
@ Caudio_array
Documents / Resources
 |
Audio Array AM-W13 Wireless Microphone [pdf] Instruction Manual AM-W13 Wireless Microphone, AM-W13, Wireless Microphone, Microphone |
