Lenz provides a diverse range of products including innovative heated clothing and body heat systems, electric vehicle charging adapters, and home fixtures.
Lenz is a multifaceted brand name representing several distinct lines of innovative consumer and commercial products. In the activewear and outdoor space, Lenz Products (Lenz Body Heat System) excels in designing advanced heated clothing, such as smart lithium-pack heated socks, heated gloves, and specialized shoe dryers that provide comfort in extreme cold.
Additionally, the Lenz brand encompasses high-quality Electric Vehicle (EV) charging solutions under Lenz Charging, offering reliable J1772 and NACS (Tesla) adapters and charger holsters to make EV charging safer and more accessible.
Beyond outdoor gear and automotive accessories, Lenz is also known for modern, drill-free bathroom and kitchen fixtures, as well as electronic components, model railway decoders, and commercial transit systems like Android bus validators. Our comprehensive library provides user manuals, installation guides, and safety instructions to help you properly set up, operate, and maintain your Lenz products.
Latest manuals from manuals+ curated for this brand.
Watch setup, installation, and troubleshooting videos for this brand.
Common questions about manuals, registration, and support for this brand.
Lenz Heat Socks are machine washable at 30 degrees Celsius on a gentle cycle. Always wash them in the supplied washing bag, hang to dry, and avoid wringing, bleaching, or ironing.
The charging time depends on the specific battery model. The Lenz rcB 1400 takes approximately 8-9 hours, while the rcB 2000 takes 12-13 hours for a full charge in normal mode.
The LENZ ADPT-12201 adapter is rated for a maximum current of 80A and a maximum voltage of 250 VAC, supporting charging speeds up to 19.2 kW depending on the station and your EV.
Many Lenz fixtures, such as towel rings and toilet paper holders, utilize a specialized adhesive mounting base. Prepare the wall surface with alcohol, carefully knead and apply the provided adhesive packet to the mounting base, and allow it to cure for the recommended time (typically 4 to 8 hours) before attaching the fixture hardware.