GATENEAR Manuals & User Guides
GATENEAR manufactures automatic gate openers and access control accessories, including sliding and swing gate motors, wireless keypads, and remote transmitters.
About GATENEAR manuals on Manuals.plus
GATENEAR is a provider of residential and commercial gate automation systems, specializing in electric gate openers and access control solutions. The brand's product portfolio includes heavy-duty automatic sliding gate openers, single and dual swing arm operators, and compatible accessories such as the RT48 wireless keypad.
Designed for durability and ease of installation, GATENEAR systems often feature 433.92MHz remote control frequency, infrared safety sensors, and IP54 weather-resistant protection. These products are engineered to provide secure and convenient driveway access for homes and businesses.
GATENEAR manuals
Latest manuals from manuals+ curated for this brand.
SW300DC-1 Swing Gate Opener
GATENEAR manuals from online retailers
Gatenear DC Motor Automatic Sliding Gate Opener (Model GOCA-14DC) User Manual
Gatenear Automatic Sliding Gate Opener (1400lb High Speed, Model GOCA) Instruction Manual
Gatenear Automatic Sliding Gate Opener Instruction Manual
GATENEAR support FAQ
Common questions about manuals, registration, and support for this brand.
-
How do I reset the password on my GATENEAR RT48 wireless keypad?
To reset the password, remove the battery, press and hold any button for 2 seconds while reinserting the battery, then release the button. The LEDs should light up and turn off, indicating the password has reset to '000000'.
-
What type of battery does the GATENEAR keypad remote use?
The GATENEAR RT48 wireless keypad typically uses a CR2450 3V battery. If the voltage drops below 2.4V, the LEDs '1' and '2' may light up to indicate a low battery.
-
How do I pair the GATENEAR keypad with the gate receiver?
Press the learning button on your receiver until the LED turns red. Then, enter the password on the keypad (Mode 1 or 2). The receiver LED should flash and turn green to confirm the pairing is complete.