Balboa Water Group is a leading global manufacturer of electronic control systems, pumps, jets, and heating solutions for the leisure water industry, specifically portable spas and hot tubs.
Balboa Water Group is the world's largest manufacturer of electronic control systems for the spa and hot tub industry. Renowned for their reliability and innovation, Balboa designs and produces a comprehensive range of critical components including spa packs, topside control panels, pumps, jets, and WiFi modules. Their systems, such as the BP and VS/GS series, are the backbone of countless spa brands worldwide, offering advanced features like M7 temperature sensor technology and mobile app integration.
With a focus on engineering excellence, Balboa provides user-friendly interfaces suitable for both standard consumer hot tubs and complex swim spas. Their product line extends to bath products and therapeutic water systems. This page serves as a repository for Balboa user manuals, installation guides, and troubleshooting documentation to assist owners and technicians in maintaining and operating their spa equipment efficiently.
Latest manuals from manuals+ curated for this brand.
Watch setup, installation, and troubleshooting videos for this brand.
Common questions about manuals, registration, and support for this brand.
'Pr' indicates Priming Mode. This occurs when the spa is first powered on and lasts about 4-5 minutes. It allows you to run the pumps to purge air from the plumbing before the heater engages. You can exit this mode manually by pressing a temperature button, or wait for it to finish automatically.
HL (High Limit) or HFL (Heater Flow Low) codes indicate a flow problem or potential overheat. Ensure your water level is correct, filters are clean, and all jets/valves are open. If the heater detects a significant difference between sensors or a lack of water flow, the system shuts down to prevent damage.
On most Balboa panels (like the TP series), press 'Temp' then 'Light' repeatedly until you see 'FLTR' or 'F1'. Press 'Temp' to enter the menu, then use 'Temp' to adjust the start time and duration. Ensure you press 'Light' or the menu button to save your changes.