bhs logo

QCS605 AI Box Edge Computing Device
User ManualBHS QCS605 AI Box Edge Computing Device

USER MANUAL QCS605 AI BOX

QCS605 AI Box Edge Computing Device

Dimensions

BHS QCS605 AI Box Edge Computing Device - Dimensions

Physical Description

  1. Outer ViewBHS QCS605 AI Box Edge Computing Device - Outer View
  2. Mode Button
    Mode button is used in this device is tactile switches type, user-developed operating script.
  3. Reset Button
    The reset button is used to factory reset the device.
    Reset procedure: Unplug the Box B01 -> Hold down the reset button -> Plug in the power -> Continue to hold for about 10 seconds and then release it -> Box will  perform a factory reset and boot up at the Google Setup Wizard screen
  4. USB Type C
    One port USB Type C 3.1 is available in this device for debug and flashing images.
  5. HDMI
    One port HDMI 1.4 Type A is available in this device for transmitting images, videos to external devices such as monitors.
  6. Alarm I/O (DI/DO terminal)
    Various I/O supports including Alarm-in, Alarm-out (Relay).
    DI1+ 1st  Alarm input signal line terminal, positive
    DI1- 1st Alarm input signal line terminal, negative (GND)
    DI2+ 2nd Alarm input signal line terminal, positive
    DI2- 2nd Alarm input signal line terminal, negative (GND)
    DOA 1St Alarm output signal line terminal 1
    DOB 1St Alarm output signal line terminal 2
    DOC 2ndAlarm output signal line terminal 1
    DOD 2nd Alarm output signal line terminal 2

    Two alarm outputs with NO contacts of IM06GR (TE) relay:
    • Switching power: 60W/62.5VA
    • Switching voltage: 220VDC/250VAC
    • Switching current: 2A
    Two alarm inputs can support input voltage level are 5VDC to 12VDC.

  7. LEDs
    System Power  Green LED Power is ON/OFF
    Status RG LED User-developed operating script.
    LAN RG  LED User-developed operating script.
  8. SD Card
    QCS605 supports Micro SD Card up to 2TB.
  9. Hardware Installation.
    1. Install the dual Wifi Antenna.BHS QCS605 AI Box Edge Computing Device - Wifi Antenna 2. Install the GPS Antenna.
    BHS QCS605 AI Box Edge Computing Device - GPS Antenna3. Install Mic, Audio, USB Type-C, Micro HDMI
    BHS QCS605 AI Box Edge Computing Device - Micro HDMI4. Install SD Card.BHS QCS605 AI Box Edge Computing Device - SD Card5. Install DI/DO
    a. Install Terminal connector.

    BHS QCS605 AI Box Edge Computing Device - Terminalb. Installing Cable DI/DO to block terminal. Then, to use Screwdriver fix the cable.BHS QCS605 AI Box Edge Computing Device - Screwdriver fix

bhs logo

Documents / Resources

BHS QCS605 AI Box Edge Computing Device [pdf] User Manual
QCS605, AI Box Edge Computing Device, QCS605 AI Box Edge Computing Device, Edge Computing Device, Computing Device

References

Leave a comment

Your email address will not be published. Required fields are marked *