User Manual for BHS models including: QCS605, AI Box Edge Computing Device, QCS605 AI Box Edge Computing Device, Edge Computing Device, Computing Device
P a g e 5 | 8 USER MANUAL AI BOX 7. LEDs System Power Green LED Power is ON/OFF Status RG LED User-developed operating script. LAN RG LED User-developed operating script.
QCS605 AI Box edge computing device | Bkav Hardware Solution (BHS)
USER MANUAL QCS605 AI BOX USER MANUAL AI BOX Page 1|8 Dimensions USER MANUAL AI BOX Page 2|8 Physical Description 1. Outer View USER MANUAL AI BOX PWR/STATUS/LAN LEDs MODE BUTTON Wifi GPS MIC Wifi DC 12V LAN USB HDMI DI/DO Type-C terminal Audio SD Card Reset Page 3|8 USER MANUAL AI BOX 2. Mode Button Mode button is used in this device is tactile switches type, user-developed operating script. 3. Reset Button The reset button is used to factory reset the device. Reset procedure: Unplug the Box B01 -> Hold down the reset button -> Plug in the power -> Continue to hold for about 10 seconds and then release it -> Box will perform a factory reset and boot up at the Google Setup Wizad screen 4. USB Type C One port USB Type C 3.1 is available in this device for debug and flashing images. 5. HDMI One port HDMI 1.4 Type A is available in this device for transmitting images, videos to external devices such as monitors. 6. Alarm I/O (DI/DO terminal) Various I/O supports including Alarm-in, Alarm-out (Relay). DI1+ 1st Alarm input signal line terminal, positive DI1- 1st Alarm input signal line terminal, negative (GND) DI2+ 2nd Alarm input signal line terminal, positive DI2- 2nd Alarm input signal line terminal, negative (GND) DOA 1st Alarm output signal line terminal 1 DOB 1st Alarm output signal line terminal 2 DOC 2nd Alarm output signal line terminal 1 DOD 2nd Alarm output signal line terminal 2 Two alarm outputs with NO contacts of IM06GR (TE) relay: Switching power: 60W/62.5VA Switching voltage: 220VDC/250VAC Switching current: 2A Two alarm inputs can support input voltage level are 5VDC to 12VDC. Page 4|8 USER MANUAL AI BOX 7. LEDs System Power Green LED Power is ON/OFF Status RG LED User-developed operating script. LAN RG LED User-developed operating script. 8. SD Card QCS605 supports Micro SD Card up to 2TB. 9. Hardware Installation. 1. Install the dual Wifi Antenna. Page 5|8 2. Install the GPS Antenna. USER MANUAL AI BOX GPS Antenna 3. Install Mic, Audio, USB Type-C, Micro HDMI USB Type-C HDMI Mic Audio Page 6|8 4. Install SD Card. USER MANUAL AI BOX 5. Install DI/DO a. Install Terminal connector. SD Card Page 7|8 USER MANUAL AI BOX b. Installing Cable DI/DO to block terminal. Then, to use Screwdriver fix the cable. Page 8|8Microsoft Word 2013 Microsoft Word 2013