Hardware
Digital Lever with Keypad
DD1-L Digital Lever with Keypad
Read this manual carefully before installing and operating!
For any problems or issues, please contact support@ibestten.com or 1-800-358-6160. Our technical team will help you sort it out.
Not Waterproof
BESTTEN electronic door locks are not waterproof and should not be installed where they will be exposed to rain or other wet conditions.
Installation and Operation Guide
https://wx.hlcode.cn/?id=NiD80Yh
Installation Overview
Package Includes:
A Exterior Assembly -1
B Interior Assembly -1
C Mounting Plate -1
D AA Alkaline Batteries -4
E Keys -2
F Latch -1
G Strike Plate -1
H User Guide -1
I 1 1/8” Screw -1
J 1” Screw -2
K 5/16” Screw -2
L 3/4” Screw -4
M Optional Set Screw -1 
Please carefully check the above list to confirm all items have been received.
If any items are missing, please contact BESTTEN Customer Care.
Prepare Door
Refer to Template for Door Prep Instructions Included in Packaging.
NOTE: Skip this step if your door comes with pre-drilled holes.
Install Latch and Strike Plate
To convert between 2-3/8″ (60mm) and 2-3/4″ (70mm) backset
1. Pull or push the extension plate to the required size.
Determine Door “Handing” and Install Lock Handle
View from the front of the lock
Reminder: Tail piece must be in the horizontal position only when removing or installing handles.
Change Lever Handing (Optional)
Reminder: Tail piece must be in the horizontal position only when removing or installing handles.
Install Exterior Assembly
Check that the rubber gasket is secured on the exterior assembly. Place the exterior assembly onto the door with the tail piece going through the latch assembly. Route the control wire through the door over the latch assembly.
Tail Piece (Vertical)
The Tail Piece that goes through the door and connects the lock (See Diagram) MUST be in the VERTICAL position (Up and Down) during installation.
IF THE TAIL PIECE IS NOT IN THE VERTICAL POSITION DURING INSTALLATION, THE LOCK WILL NOT FUNCTION CORRECTLY.
Do Not Over Tighten
Install Wiring Connector
Work with the Door Open
Control Wire
Make sure that all the pins on the control wire connector are straight and that the connector is fully installed and firmly connected.
Install Interior Assembly
NOTE: Make sure the tail piece and knob are both set in the VERTICAL position.
Be careful not to pinch the control wire when assembling.
Test the Lock
Test the Lock
Check the Lock/Unlock function and that the Lever fully retracts the Latch. 
This electronic lock requires (4) High Quality AA alkaline batteries.
When all 4 batteries are installed in the correct position, you should hear 2 beeps and the keypad will illuminate.
NOTE: Do not touch the keypad until the light turns off. Do not use rechargeable batteries or non-alkaline batteries.
Test Operation
Test that all buttons on the keypad are working.
Default Administrator Code:123456
Default User Code:1234
Both Administrator Code and User Code can open the door
Before Opening Door, Let Motor Complete Cycle.
BESTTEN
Hardware
Programming Instructions
Test the keypad to ensure all the buttons work.
During programming, if there are no inputs for 5 seconds, the programming will exit and fail to complete.
Please change the Administrator Code and User Code as soon as possible after installation to insure security.
AC
Administrator Code
Default:123456
UC
User Code (4-8 digits)
Default:1234
ID
User ID (01-50, 2 digits)
Each User Code is linked to a User ID
Change Administrator Code
Add a User Code
When a NEW User Code is set, the default User Code (1234) is deleted for safety.
Unlock Door with User Code
Delete a User Code
Delete All User Codes
Additional Programming Functions
Programming Symbols
Lock / Clear
Unlock / Programming
Administrator Code
Automatic Lock Function
SET OR CANCEL AUTO LOCK
You can set the lock to automatically lock after each time the lock is unlocked.
Time value range = 20 – 900 seconds, enter the following:
Set Auto Lock:
1 beep and green light confirms successful programming.
Cancel Time Value Auto Lock:
TEMPORARILY DISABLE:
While in Auto-Lock mode, unlock door using , within 5 seconds you must turn the locking knob by hand to the locked position, and then turn the locking knob back to the unlock position. The Auto-Lock mode is now disabled.
RESTORE:
To restore the Auto-Lock function, turn the locking knob by hand to the locked position, wait more than 2 seconds or press the Lock button on the keypad.
Vacation Mode
With Vacation Mode enabled, the system enters into low-power consumption mode. During this mode, all buttons and functions will be disabled until they are re-enabled.
ENABLE:
Once the door is locked then vacation mode will be engaged and all buttons and functions will be disabled
DISABLE:
To disable the Vacation Mode, you must press and hold for more than 3 seconds, then input followed by to unlock the door. Vacation Mode is now disabled.
NOTE: If you only press the for more than 3 seconds but do not input , the system will remain in Vacation Mode.
Secure Lock-out Period
Warning sounds and LED flashes red after 4 incorrect code attempts: Keypad shuts down for 60 seconds.
SOUND ON AND OFF
You can “mute” or turn the “sound on” on your lock by entering the following.
(Factory setting is sound on).
Sound Off (1) – Light Indicator illuminates green.
Sound On (2) – Hear 1 beep and Light Indicator illuminates green.
Restore Factory Settings
To reset the lock to the original factory settings including the
Admin Code and all User Codes follow these steps:
- Remove one battery for 10 seconds.
- Reinsert the battery and wait for a long and short beep.
- Quickly Press 3 times within 3 seconds (before the blue light turns off).
- The lock will beep and the light indicator will turn green.
Low Battery Warning
Beeps and LED flashes red 7 times. Replace with high quality alkaline batteries.
Note: Removing batteries does not erase active Administrator or User Codes.
Function Guide
| Unlock / Valid programming: | 1 long beep and LED illuminates green |
| Lock: | 2 short beeps and LED illuminates red |
| Invalid programming: | 2 short beeps and LED flashes red twice |
| Low voltage: | Short beeps and LED flashes red seven times |
| Super low voltage： | 4 short beeps and LED flashes red four times |
| 4 Incorrect code entry attempts: | 2 short beeps and LED illuminates red each attempt |
| Power on: | 1 long beep and 1 short beep and LED illuminates green |
| Lock error: | 3 long beeps and LED flashes red three times |
Troubleshooting
| Issue | Solution |
| Interior Knob will not turn | Knob or vertical tailpiece is installed in incorrect position. • Remove Interior Assembly and verify that the locking knob and tailpiece are vertical. |
| Lock will not function electronically | • Check that all batteries are high quality Alkaline Batteries. • Check for proper polarity (+-)of all batteries. • Check that the Control Wire is attached to the Interior Assembly and not damaged. • Check each wire for loose or disconnected wires. • Disconnect the wiring harness and reconnect the wiring harness. • Restore to factory settings |
| Keypad not working | • Wait 60 seconds, keypad may be locked out due to incorrect code. • Replace with 4 high quality alkaline batteries. • Ensure Wiring connector is fully engaged and secure. |
| Keypad beeps and LED flashes | • Replace with 4 high quality alkaline batteries. |
Contact Us First! Do Not Return to Store
WARRANTY
BESTTEN warrants to the original customer that this product is free of defects in materials and workmanship for 3 years from the purchase date. Within this period, simply contact BESTTEN CARE with proof of purchase and reason of claim. We will replace the product for free.
Any product which is subject to misuse or accidental damage is excluded from this warranty.
BESTTEN CARE
support@ibestten.com
1-800-358-6160 (Mon-Fri 9AM-5PM PST)
For more products from BESTTEN, please visit our website www.ibestten.com.
Installation and Operation Guide
https://wx.hlcode.cn/?id=NiD80Yh
Documents / Resources
 |
BESTTEN DD1-L Digital Lever with Keypad [pdf] Instruction Manual DD1-L Digital Lever with Keypad, DD1-L, Digital Lever with Keypad, Lever with Keypad, Keypad |
 |
BESTTEN DD1-L Digital Lever with Keypad [pdf] Instruction Manual DD1-L Digital Lever with Keypad, DD1-L, Digital Lever with Keypad, Lever with Keypad, Keypad |