AURATON SMART Floor Heating Controller User Manual

AURATON SMART Floor Heating Controller

Description

Description of the device, the push buttons, and the indicator lights

1. LED indicating the status of the power supply
2. LED indicating the status of operation of the pump or the central heating furnace
3. Button (Del) for evaporating controllers or returning to factory settings
4. Button (Link) for pairing with the AURATON Pulse control unit
5. Button (Test) with indicator of the tester function mode
6. 230 V AC power connection
7. Network switch
8. NC, COM, NO, potential-free contacts of the transmitter
9. Control of the central heating pump
10. Terminals of heating zones 1-8 (actuators)
11. Heating zone buttons 1-8
12. LEDs indicating operation of zones 1-8
13. Connection for an external temperature sensor
14. Antenna

DIN rail mounting

1. DIN rail
2. Hook the AURATON Floor Heating Controller onto the DIN rail with the upper hooks.
3. Pull the lower hook down with a „flat” screwdriver.
4. Put AURATON Floor Heating Controller in the right place.
5. Release the lower hook.

SMART wireless control strip for underfloor heating
The AURATON Floor Heating Controller is SMART, 8-zone, wireless underfloor heating control strip, designed to work with AURATON Vela actuators, a central heating pump and a heating device.

WARNING! All connections should be made when power source is disconnected.
WARNING! AURATON Floor Heating Controller is designed for mounting on a DIN-rail in the installation cabinets. Metal cabinets should not be used due to hindered radio communication.

Signaling the operation of AURATON Floor Heating Controller:

Signaling in normal state:

Signaling in the TEST state:

ATTENTION: For easy installation, the terminals are equipped with removable clamps. Before cable connections are made, they can be disconnected from AURATON Floor Heating Controller.
WARNING: All connections should be made when power source is disconnected.

• Only one AURATON wireless controller can be paired to a given zone.

Connection

Connection of the central heating furnace
The central heating furnace must be connected to the COM–NO or COM-NC clamps. This is a standard one-pole bistate transmitter. In most cases, the NC clamp is not used.

1. Actuators
2. Central heating pump
3. Heating device e.g. gas boiler
4. External temperature sensor

Connecting more actuators to one zone

1. Actuators (max 6 per 1 zone)

Pairing the AURATON Floor Heating Controller with the AURATON Heat Monitor

Pairing the AURATON Floor Heating Controller with the AURATON Pulse

Technical data

Disposing of the devices
The device is marked with a symbol of a crossed waste bin. Pursuant to European Directive 2012/19/EU and to the Act on waste electrical and electronic equipment, such mark indicates that the device, at the end of its service life, must not be disposed of together with other household waste. The user is responsible for delivering the devices to a reception point for used-up electric and electronic equipment. Hereby, LARS Andrzej Szymanski declares that the radio equipment type AURATON Floor Heating Controller is in compliance with Directive 2014/53/EU and 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: https://manuals.auraton.pl

Manufacturer
LARS Andrzej Szymański, Świerkowa 14,
64-320 Niepruszewo, POLAND
www.auraton.pl