Franke FTT 6322 XS Kitchen Hood User Manual

1. Product Overview

The Franke FTT 6322 XS Kitchen Hood is an under-cabinet stainless steel cooker hood designed for efficient air extraction in your kitchen. It features two powerful motors and can operate using either carbon filters for recirculation or external expulsion for ducted ventilation. With a maximum capacity of 380 m³/h, it effectively removes smoke, steam, and cooking odors, ensuring a fresh kitchen environment.

Figure 1: Front view of the Franke FTT 6322 XS Kitchen Hood, showcasing its sleek stainless steel design suitable for under-cabinet installation.

2. Safety Information

Before installation and use, please read all safety instructions carefully. Keep this manual for future reference.

• Ensure the electrical supply matches the rating plate on the appliance.
• Installation must be performed by a qualified technician in accordance with local regulations.
• Do not operate the hood without filters properly installed.
• Regularly clean grease filters to prevent fire hazards.
• Do not flambé under the range hood.
• Adequate ventilation must be provided when the range hood is used simultaneously with appliances burning gas or other fuels.

3. Setup and Installation

This section provides guidelines for the proper installation of your Franke Kitchen Hood. It is crucial to follow these steps to ensure optimal performance and safety.

3.1. Unpacking

Carefully remove the hood from its packaging. Inspect for any damage during transit. Retain packaging materials for potential future transport or return.

3.2. Mounting Options

The FTT 6322 XS is designed for under-cabinet mounting. Ensure the cabinet structure is robust enough to support the hood's weight.

3.3. Ventilation Modes

The hood supports two ventilation modes:

• External Expulsion (Ducted): Air is extracted and expelled outside through a ducting system. This requires a connection to an external vent.
• Recirculation (Filtered): Air is filtered through carbon filters to remove odors and then recirculated back into the kitchen. This mode is used when external venting is not possible.

3.4. Dimensions and Clearance

Refer to the technical drawing for precise dimensions and recommended clearances for installation.

Figure 2: Technical drawing illustrating the dimensions (in millimeters) of the Franke FTT 6322 XS Kitchen Hood, including width (598mm), depth (482mm), height (150mm), and ducting diameter (Ø100-120mm).

3.5. Electrical Connection

Connect the hood to a grounded electrical outlet. Ensure the voltage matches the product specifications (240 Volts, 230 watts).

4. Operating Instructions

Your Franke Kitchen Hood is designed for ease of use. Familiarize yourself with the controls for optimal performance.

4.1. Control Panel

The control panel is located on the front of the hood and typically includes buttons for fan speed and lighting.

4.2. Fan Speed Selection

Press the fan speed button to cycle through different extraction levels. Start with a lower speed for light cooking and increase for heavier cooking or strong odors. The hood features two motors for efficient air movement.

4.3. Lighting

Press the light button to turn the halogen lights on or off, illuminating your cooking area.

4.4. Recommended Usage

For best results, turn on the hood a few minutes before you start cooking and leave it on for a few minutes after you finish to ensure all steam and odors are cleared.

5. Maintenance and Cleaning

Regular maintenance ensures the longevity and efficiency of your kitchen hood.

5.1. Cleaning the Exterior

Clean the stainless steel exterior with a soft cloth and a non-abrasive cleaner specifically designed for stainless steel. Avoid harsh chemicals or abrasive pads that can scratch the surface.

5.2. Grease Filter Cleaning

The metal grease filters should be cleaned regularly, typically every 2-4 weeks depending on usage. They can be washed by hand with hot soapy water or in a dishwasher on a low-temperature cycle.

1. Switch off the power supply to the hood.
2. Remove the grease filters by releasing their latches.
3. Clean the filters as described above.
4. Allow filters to dry completely before re-installing.

5.3. Carbon Filter Replacement (for Recirculation Mode)

If your hood operates in recirculation mode, the carbon filters (included components) need to be replaced periodically, usually every 3-6 months, depending on cooking frequency. Carbon filters cannot be washed and reused.

1. Switch off the power supply.
2. Remove the grease filters to access the carbon filters.
3. Remove the old carbon filters and dispose of them.
4. Install new carbon filters according to the manufacturer's instructions.
5. Re-install the grease filters.

5.4. Light Bulb Replacement

The hood uses halogen light bulbs. To replace a bulb:

1. Ensure the hood is switched off and the bulb has cooled down.
2. Carefully remove the old bulb.
3. Insert a new bulb of the same type and wattage.

6. Troubleshooting

This section provides solutions to common issues you might encounter with your kitchen hood.

If the problem persists after attempting these solutions, please contact Franke customer support.

7. Specifications

Detailed technical specifications for the Franke FTT 6322 XS Kitchen Hood.

• Model: FTT 6322 XS
• Brand: Franke
• Type: Under Cabinet Cooker Hood
• Material: Stainless Steel
• Dimensions (W x D x H): 598mm x 482mm x 150mm
• Max Capacity: 380 m³/h (380 CMPH)
• Motors: 2
• Filter Type: Carbon filters (for recirculation), Metal grease filters (standard)
• Ventilation Type: Convertible (External Expulsion or Recirculation)
• Light Source: Halogen
• Wattage: 230 watts
• Voltage: 240 Volts
• Item Weight: 222 g
• Color: Silver
• Finish Type: Brushed
• Made in: Turkey

8. Warranty Information

The Franke FTT 6322 XS Kitchen Hood comes with a 5-year warranty from the date of purchase. This warranty covers manufacturing defects and faulty materials under normal domestic use. Please retain your proof of purchase for warranty claims.

The warranty does not cover:

• Damage caused by improper installation or use not in accordance with this manual.
• Normal wear and tear, including filters and light bulbs.
• Damage caused by unauthorized repairs or modifications.
• Damage from external factors such as power surges or natural disasters.

9. Customer Support

For technical assistance, spare parts, or warranty claims, please contact Franke customer service. Have your product model number (FTT 6322 XS) and proof of purchase ready when contacting support.

For more information, you may visit the official Franke website: www.franke.com