Lepro LED Headlamp (Model 3200008-3) Instruction Manual

1. Introduction

Thank you for choosing the Lepro LED Headlamp. This manual provides essential information for the safe and efficient use of your new headlamp. Please read it thoroughly before operation and retain it for future reference.

This rechargeable headlamp is designed for various outdoor and indoor activities, offering multiple lighting modes and a comfortable, durable design.

2. Key Features

• Super Bright Illumination: Features 150 lumen LEDs, capable of illuminating up to 150 feet.
• 5 Light Modes: Includes 3 levels of white light brightness (High, Low, Strobe) and 2 modes of red light (Steady On, Flash).
• USB Rechargeable: Compatible with any USB port, providing up to 30 hours of continuous lighting on a single charge (Low mode). Micro USB charging cable included.
• Lightweight & Comfortable: Weighs only 2.86 oz (81g) with a sweat-proof elastic headband and 45° adjustable angle for optimal comfort.
• IPX4 Waterproof: Designed to withstand heavy rain and splashing water, suitable for various outdoor conditions.
• Durable Construction: Made with polyethylene coating for reliable protection against drops and scratches.

3. Setup and Charging

3.1 Initial Charge

Before first use, fully charge the headlamp. The battery is partially charged from the factory but a full charge ensures optimal performance.

3.2 Charging Instructions

1. Locate the micro USB charging port on the side of the headlamp. It is protected by a rubber flap.
2. Gently lift the rubber flap to expose the port.
3. Connect the included micro USB cable to the headlamp's charging port.
4. Connect the other end of the USB cable to a 5V DC adapter (not included), a computer USB port, a power bank, or a car charger.
5. A red indicator light will illuminate during charging. The light will turn green or off when fully charged.
6. Charging typically takes approximately 4 hours for a full charge.
7. Once charging is complete, securely close the rubber flap to maintain the IPX4 waterproof rating.

Image: Headlamp connected to a USB cable for charging, illustrating battery life for different modes.

Image: Various compatible USB charging sources for the headlamp.

4. Operating Instructions

4.1 Power On/Off and Mode Selection

The headlamp features two main buttons for operation: one for white light modes and one for red light modes.

• White Light Button: Press once to cycle through High Brightness, Low Brightness, White Light Flash, and Off.
• Red Light Button: Press once to cycle through Red Light Steady On, Red Light Flash, and Off.
• To turn off the headlamp from any mode, cycle through the modes until it turns off, or press and hold the active mode button for a few seconds.

Image: Visual representation of the 5 available lighting modes.

4.2 Adjusting the Beam Angle

The headlamp unit can be tilted up to 45 degrees to direct the light precisely where needed. Gently push or pull the light unit to adjust its angle.

Image: Headlamp unit demonstrating 45-degree tilt capability.

4.3 Adjusting the Headband

The elastic headband is adjustable to fit various head sizes, suitable for both adults and children. Use the buckle on the strap to lengthen or shorten it for a secure and comfortable fit.

Image: Adjustable elastic headband for a comfortable fit.

5. Maintenance

• Cleaning: Wipe the headlamp body with a soft, damp cloth. Do not use abrasive cleaners or solvents.
• Headband Care: The elastic headband is removable and washable. Hand wash with mild soap and water, then air dry.
• Storage: Store the headlamp in a cool, dry place away from direct sunlight when not in use for extended periods.
• Battery Life: To prolong battery life, charge the headlamp at least once every 3 months, even if not in regular use.
• Waterproof Seal: Ensure the rubber flap covering the charging port is always securely closed when not charging to maintain its IPX4 water resistance.

Image: Headlamp demonstrating IPX4 water resistance.

6. Troubleshooting

• Headlamp not turning on: Ensure the battery is charged. Connect to a power source and check if the charging indicator light appears.
• Light is dim: The battery may be low. Recharge the headlamp.
• Charging indicator not working: Check the USB cable and power source connections. Try a different cable or adapter.
• Headlamp not holding a charge: Ensure the charging port is clean and free of debris. If the issue persists, contact customer support.
• Water ingress: Ensure the rubber flap over the charging port is always fully sealed when not charging. If water enters, allow the unit to dry completely before attempting to use or charge.

7. Specifications

8. Warranty and Support

8.1 Warranty Information

This product comes with a 1-year warranty from the date of purchase. The warranty covers manufacturing defects and material flaws under normal use. It does not cover damage caused by misuse, accidents, unauthorized modifications, or normal wear and tear.

8.2 Customer Support

For any questions, technical assistance, or warranty claims, please contact Lighting EVER customer support through the retailer's platform or the official Lighting EVER website. Please have your model number (3200008-3) and proof of purchase ready.

9. Additional Resources

9.1 Official Product Video