1. Introduction
Thank you for choosing the RL LIVE YOUR LIGHT E27 Table Lamp. This manual provides essential information for the safe and efficient use of your new lamp. Please read it thoroughly before installation and operation, and retain it for future reference.
2. Safety Instructions
- Ensure the power supply is disconnected before installation, cleaning, or maintenance.
- This lamp is designed for indoor use only (IP20 rating). Do not expose to moisture or extreme temperatures.
- Use only E27 bulbs with a maximum wattage of 60W.
- Do not touch the bulb immediately after use, as it may be hot.
- Keep away from flammable materials.
- If the power cord is damaged, it must be replaced by a qualified electrician to avoid hazards.
- Dispose of broken bulbs according to local regulations. Refer to the Maintenance section for more information.
3. Product Overview
The RL LIVE YOUR LIGHT E27 Table Lamp features a contemporary design with a gold ceramic base and a black fabric lampshade. It is designed to provide ambient lighting for various indoor settings.
Figure 3.1: Front view of the RL LIVE YOUR LIGHT E27 Table Lamp with its black fabric shade and gold ceramic base.
Figure 3.2: The RL LIVE YOUR LIGHT E27 Table Lamp placed on a surface, showcasing its design within a typical room environment.
Figure 3.3: A detailed view of the lamp's gold ceramic base and the texture of the black fabric lampshade.
Package Contents:
- 1 x RL LIVE YOUR LIGHT E27 Table Lamp (Model: R50841079 Gizeh)
- Note: Bulb is not included.
4. Setup
4.1 Unpacking
- Carefully remove all components from the packaging.
- Inspect the lamp for any signs of damage. If damaged, do not proceed with installation and contact customer support.
- Retain packaging materials for future transport or return, if necessary.
4.2 Assembly
- Place the lamp base on a stable, flat surface.
- Ensure the lampshade is securely attached to the lamp holder.
- Screw an E27 bulb (max. 60W) into the lamp holder. Ensure the bulb is fully seated but do not overtighten.
- Plug the lamp's power cord into a standard electrical outlet.
Figure 4.1: Dimensional drawing of the lamp, showing its height of 34.5 cm and base dimensions of approximately 190x100 mm, along with the E27 bulb fitting and pull chain switch.
5. Operating Instructions
The RL LIVE YOUR LIGHT E27 Table Lamp is operated via a pull chain switch.
- To turn the lamp ON, gently pull the chain switch once.
- To turn the lamp OFF, gently pull the chain switch again.
Ensure the lamp is placed on a stable surface and the power cord is not a tripping hazard.
6. Maintenance
6.1 Cleaning
- Always disconnect the lamp from the power supply before cleaning.
- Wipe the lamp base and shade with a soft, dry cloth.
- Do not use abrasive cleaners, solvents, or polishes, as they may damage the finish.
6.2 Bulb Replacement
- Ensure the lamp is unplugged and the bulb has cooled down completely before attempting to replace it.
- Carefully unscrew the old E27 bulb counter-clockwise.
- Screw in a new E27 bulb (max. 60W) clockwise until secure.
6.3 Recycling and Disposal
This product contains electrical and electronic components that should not be disposed of with household waste. Please refer to your local regulations for proper recycling and disposal of electrical products and light bulbs.
For information on recycling light bulbs, please visit: Bulb Recycling Information
For information on cleaning and disposing of broken or damaged lamps, please visit: Information on Broken Bulbs
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Lamp does not light up. | No power supply. | Check if the plug is securely inserted into the outlet. Test the outlet with another device. |
| Bulb is faulty or not installed correctly. | Ensure the bulb is screwed in tightly. Replace the bulb with a new one. | |
| Pull chain switch is faulty. | If the above steps do not resolve the issue, the switch may be faulty. Contact customer support. | |
| Flickering light. | Loose bulb connection. | Unplug the lamp, then re-tighten the bulb. |
| Incompatible bulb. | Ensure you are using an E27 bulb within the specified wattage (max 60W). |
8. Specifications
| Feature | Detail |
|---|---|
| Brand | RL LIVE YOUR LIGHT |
| Manufacturer | Reality Leuchten |
| Model Number | R50841079 Gizeh |
| Dimensions (L x W x H) | 15 x 24 x 34.5 cm |
| Weight | 875 grams |
| Material | Ceramic (Base), Fabric (Shade) |
| Color | Black/Gold |
| Bulb Socket Type | E27 |
| Max Wattage | 60W |
| Voltage | 230V AC |
| IP Rating | IP20 (Indoor Use Only) |
| Switch Type | Pull Chain Switch |
| Energy Efficiency Class (Light Source) | F (for removable light source) |
9. Warranty and Support
For warranty information and customer support, please contact your retailer or the manufacturer, Reality Leuchten. Keep your proof of purchase for any warranty claims.
Manufacturer: Reality Leuchten
For general inquiries or further assistance, please refer to the contact information provided by your point of purchase.
