1. Introduction
This manual provides essential information for the safe installation, operation, and maintenance of your Ancona AN-1364 Inserta Plus 36-inch Built-in Range Hood. Please read these instructions thoroughly before installation and use, and retain them for future reference.
The Ancona AN-1364 Inserta Plus is a 36-inch ducted built-in range hood designed for integration into kitchen cabinetry. It features a 420 CFM ventilation system, 3-speed electronic controls, LED lighting, and dishwasher-safe aluminum mesh filters with stainless steel decorative panels.
Image 1.1: Front view of the Ancona AN-1364 Inserta Plus 36-inch Range Hood, showcasing its sleek stainless steel design and integrated lighting.
2. Safety Information
To reduce the risk of fire, electric shock, or injury, observe the following:
- Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
- Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel-burning equipment to prevent back-drafting.
- When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
- Ducted fans must always be vented to the outdoors.
- Do not use this unit with any solid-state speed control device.
- To reduce the risk of fire, use only metal ductwork.
- Always disconnect power from the unit before servicing or cleaning.
- Clean grease laden surfaces frequently. Accumulated grease may ignite.
3. Package Contents
Verify that all components are present before beginning installation:
- Ancona AN-1364 Inserta Plus Range Hood Unit
- Aluminum Mesh Filters (pre-installed)
- Damper/Flange
- Damper Screws
- Instruction Manual (this document)
- Warranty Information
4. Setup and Installation
The Ancona AN-1364 is designed for built-in installation within kitchen cabinetry. Professional installation is recommended to ensure proper fit, ventilation, and electrical connections.
4.1 Dimensions and Cabinetry Requirements
Ensure your cabinetry provides adequate space for the range hood. The unit measures approximately 35.4 inches (90 cm) in width, 11.5 inches (29 cm) in depth, and 10 inches (25.4 cm) in height. Refer to the diagram below for detailed dimensions and the built-in style.
Image 4.1: Detailed dimensions of the range hood and a schematic illustrating its built-in installation within a cabinet.
4.2 Venting Options
The range hood requires a top 6-inch round ventilation duct. It supports both horizontal wall venting and vertical roof venting configurations. Ensure proper ductwork is installed to exhaust air outdoors.
Image 4.2: Diagrams showing typical setups for horizontal wall venting with a side wall cap and vertical roof venting with a roof cap.
4.3 Electrical Connection
The unit operates on 120 Volts. All electrical connections must comply with local codes and be performed by a qualified electrician.
5. Operating Instructions
The Ancona AN-1364 features intuitive electronic controls for fan speed and lighting.
5.1 Control Panel
The control panel is located on the front of the unit. It includes buttons for power, fan speed adjustment, and light control.
Image 5.1: Close-up view of the control panel with buttons for fan speed and light, alongside the LED lights and mesh filters.
5.2 Fan Operation
- Power On/Off: Press the power button to turn the fan on or off.
- Speed Adjustment: Use the speed control buttons to cycle through the 3 available fan speeds (Low, Medium, High). Select a speed appropriate for the cooking intensity.
- Auto Shut-off: The unit features a convenient delayed auto shut-off function, adjustable up to 10 minutes. Consult the full manual for specific programming instructions.
Image 5.2: Illustration demonstrating the range hood's effectiveness in extracting excess heat and odors from the cooking area.
5.3 Lighting
Press the light button on the control panel to turn the LED lights on or off. The two 2.55-watt LED lights provide bright illumination for your cooking surface.
6. Maintenance
Regular maintenance ensures optimal performance and longevity of your range hood. Always disconnect power before performing any maintenance.
6.1 Cleaning the Filters
The aluminum mesh filters with stainless steel decorative panels are designed to trap grease and are dishwasher-safe. Clean them regularly (e.g., monthly, depending on usage) to maintain airflow and prevent grease buildup.
- Carefully remove the filters from the range hood.
- Place the filters in a dishwasher or wash them by hand with hot water and a mild detergent.
- Ensure filters are completely dry before re-installing them.
6.2 Cleaning the Exterior
Wipe the stainless steel exterior surfaces with a clean cloth dampened with warm water and a mild, non-abrasive detergent. Dry thoroughly with a soft cloth. Avoid using abrasive cleaners or scouring pads, which can scratch the finish.
6.3 LED Lights
The LED lights are designed for long life. If replacement is ever needed, consult a qualified technician or the manufacturer's support for guidance.
7. Troubleshooting
Before contacting support, review the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Fan does not operate. | No power, circuit breaker tripped, loose wiring. | Check power supply. Reset circuit breaker. Ensure all connections are secure (consult electrician). |
| Lights do not work. | No power, faulty LED, loose connection. | Check power supply. Ensure light button is pressed. If problem persists, contact support. |
| Poor suction performance. | Clogged filters, restricted ductwork, incorrect fan speed. | Clean or replace filters. Check ductwork for obstructions. Increase fan speed. |
| Excessive noise. | Loose components, motor issue, ductwork vibration. | Ensure filters are properly seated. Check for loose screws. Inspect ductwork for proper installation. |
8. Specifications
| Feature | Detail |
|---|---|
| Model | AN-1364 |
| Dimensions (L x W x H) | 35.4 x 11.5 x 10.13 inches (900 mm x 290 mm x 254 mm) |
| Air Flow Capacity | 420 Cubic Feet Per Minute (CFM) |
| Material | High-quality 430 Stainless Steel |
| Noise Level | 2.1 Sones |
| Mounting Type | Built-In Mount |
| Controls Type | 3-Speed Electronic Push Button |
| Voltage | 120 Volts |
| Wattage | 215 watts |
| Light Source Type | 2 x 2.55-watt LED Lights |
| Filter Type | Dishwasher-safe Aluminum Mesh with Stainless Steel Panels |
| Ventilation Type | Ducted Exhaust (Top 6-inch round) |
| Certifications | cULus |
| Item Weight | 22 Pounds |
9. Warranty and Support
This product comes with a manufacturer's warranty. Please refer to the included warranty document for details regarding coverage, terms, and conditions.
For technical assistance, replacement parts, or warranty claims, please contact Ancona customer support. Contact information can typically be found on the Ancona website or within the warranty documentation provided with your product.