hansgrohe 32127000

Download PDFFree PDF. The Save button below keeps a bookmark and private notes in your account.

Hansgrohe Bidette 1jet Hand Shower Manual

Model: 32127000

1. Introduction

This manual provides instructions for the installation, operation, and maintenance of your Hansgrohe Bidette 1jet Hand Shower, Model 32127000. Please read this manual carefully before installation and use to ensure proper function and safety. Keep this manual for future reference.

Hansgrohe Bidette 1jet Hand Shower with hose and holder

Image 1: Hansgrohe Bidette 1jet Hand Shower, including the hand shower, hose, and wall holder.

2. Safety Information

Observe the following safety precautions to prevent injury or damage:

  • Ensure all connections are secure to prevent leaks.
  • Do not use abrasive cleaners or solvents on the product surfaces.
  • Installation should be performed by a qualified professional if you are unsure.
  • Protect the product from freezing temperatures.

3. Package Contents

Verify that all components are present in the package:

  • Bidette hand shower (1jet)
  • Shower holder
  • Pressure-resistant shower hose (125 cm)

4. Setup and Installation

Follow these general steps for installation. Specific plumbing requirements may vary.

  1. Preparation: Turn off the main water supply before beginning installation.
  2. Connect Hose: Attach one end of the pressure-resistant shower hose to your existing water outlet (e.g., mixer tap). Ensure a watertight seal using appropriate sealing materials if necessary.
  3. Attach Hand Shower: Connect the other end of the shower hose to the bidette hand shower. Hand-tighten first, then use a wrench if needed, being careful not to overtighten.
  4. Install Shower Holder: Choose a suitable location on the wall for the shower holder. Mark the drilling points, drill holes, insert wall plugs, and secure the holder with screws.
  5. Test: Turn on the main water supply and check for any leaks at all connection points.

Note: It is recommended to consult a professional plumber for installation if you are unfamiliar with plumbing work.

5. Operating Instructions

The Hansgrohe Bidette 1jet Hand Shower is designed for simple and efficient use.

  • Activating Water Flow: To activate the water flow, press the button or lever on the hand shower. Release to stop the flow.
  • Water Pressure: The hand shower delivers a single jet (1jet) with a maximum flow rate of 6 liters per minute at 3 bar pressure.
  • Water Conservation: This product incorporates Hansgrohe's EcoSmart technology, which helps reduce water consumption by up to 60% compared to conventional products, without compromising performance.

6. Maintenance and Cleaning

Regular cleaning ensures the longevity and optimal performance of your hand shower.

  • General Cleaning: Clean the surfaces with a soft cloth and a mild, non-abrasive cleaning agent. Rinse thoroughly with water and dry with a soft cloth.
  • Limescale Removal (QuickClean): The hand shower features QuickClean technology. To remove dirt and limescale deposits from the spray nozzles, simply rub the flexible silicone nubs with your finger. This should be done regularly to maintain spray performance.
  • Avoid: Do not use cleaning agents containing hydrochloric acid, formic acid, chlorine bleach, or acetic acid, as these can cause damage. Avoid abrasive sponges or brushes.

7. Troubleshooting

If you encounter issues, refer to the following common problems and solutions:

ProblemPossible CauseSolution
Low water flowLimescale buildup in nozzlesRub the QuickClean silicone nubs to remove limescale.
Low water flowPartially closed stopcock or clogged filterCheck if the stopcock is fully open. Clean or replace any filters in the water supply line.
Leaks at connectionsLoose connections or worn sealsTighten connections. Check and replace rubber seals/washers if damaged.

If the problem persists after attempting these solutions, please contact Hansgrohe customer support.

8. Specifications

  • Model: 32127000
  • Material: White/Chrome finish
  • Spray Type: 1jet
  • Maximum Flow Rate: 6 l/min at 3 bar
  • Hose Length: 125 cm
  • Technology: EcoSmart (water-saving), QuickClean (easy limescale removal)
  • Features: Non-return valve

9. Warranty Information

This Hansgrohe product is covered by a 5-year International Manufacturer Warranty. This warranty covers defects in material and workmanship under normal use and service. Please retain your proof of purchase for warranty claims. For full terms and conditions, refer to the official Hansgrohe warranty documentation or website.

10. Customer Support

For further assistance, technical support, or warranty claims, please contact Hansgrohe customer service. Contact details can typically be found on the official Hansgrohe website for your region.

Website: www.hansgrohe.com

© 2024 Hansgrohe. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.