EGLO 85266A Rondo Collection Round Table Lamp User Manual

Introduction

This manual provides comprehensive instructions for the safe and efficient use of your EGLO 85266A Rondo Collection Round Table Lamp. Please read this manual thoroughly before installation and operation, and retain it for future reference.

Image: The EGLO Rondo Collection Round Table Lamp, featuring a frosted opal glass ball shade on a silver base.

Safety Information

Observe the following safety precautions to prevent injury or damage to the product:

• Indoor Use Only: This lamp is designed for indoor, dry locations only. Do not use in wet or damp environments.
• Electrical Safety: Ensure the power outlet matches the lamp's voltage requirements (120 Volts). Always unplug the lamp from the power source before cleaning, changing the bulb, or performing any maintenance.
• Bulb Type: Use only the specified bulb type (E26 A19) and do not exceed the maximum wattage (60W). Using an incorrect bulb may cause overheating or damage.
• Placement: Place the lamp on a stable, flat surface to prevent tipping. Keep away from flammable materials.
• Cord Care: Do not place the power cord under rugs or in areas where it can be damaged or create a tripping hazard. Do not pull the cord to unplug the lamp.
• Legal Disclaimer: Please check your local laws before purchasing and installing this product.

Package Contents

Verify that all components are present and undamaged upon unpacking:

• 1 x EGLO 85266A Rondo Collection Round Table Lamp (Base and Glass Shade)

Note: The required E26 A19 bulb is not included and must be purchased separately.

Setup and Installation

Follow these steps to set up your table lamp:

1. Unpack: Carefully remove all components from the packaging. Retain packaging for future transport or returns.
2. Bulb Installation:
   • Ensure the lamp is unplugged from the power outlet.
   • Gently remove the glass shade to access the bulb socket.
   • Screw an E26 A19 bulb (maximum 60W) into the socket until secure. Do not overtighten.
   • Carefully reattach the glass shade.
3. Placement: Position the lamp on a stable, level surface in your desired indoor location. Ensure the power cord can reach an outlet without being stretched or obstructed.

Image: A close-up view of the EGLO Rondo lamp, illustrating the silver base and frosted opal glass shade assembly.

Operation

To operate your EGLO Rondo Table Lamp:

1. Connect to Power: Plug the lamp's power cord into a standard 120V electrical outlet. The cord length is approximately 65 inches (165 cm).
2. Turn On/Off: Locate the on/off switch on the power cord. Press the switch to turn the lamp on or off.

Image: The EGLO Rondo lamp placed on a shelf, showing the power cord with its integrated on/off switch.

Maintenance

Regular maintenance ensures the longevity and appearance of your lamp:

• Cleaning: Disconnect the lamp from the power supply before cleaning. Use a soft, dry cloth to wipe the base and glass shade. Do not use abrasive cleaners or solvents, as these can damage the finish.
• Bulb Replacement: When the bulb needs replacing, ensure the lamp is unplugged and the bulb has cooled down. Follow the bulb installation steps outlined in the 'Setup and Installation' section.

Troubleshooting

If you encounter issues with your lamp, refer to the following common solutions:

• Lamp Does Not Turn On:
  • Check if the lamp is securely plugged into a working electrical outlet.
  • Verify that the on/off switch on the cord is in the 'on' position.
  • Inspect the bulb to ensure it is screwed in correctly and is not burnt out. Replace if necessary.
  • Test the outlet with another device to confirm it is receiving power.
• Light Flickers:
  • Ensure the bulb is screwed in tightly.
  • Try a different bulb to rule out a faulty bulb.
  • Check the electrical connection at the wall outlet.

If problems persist after attempting these solutions, contact EGLO customer support for assistance.

Specifications

Warranty and Support

For warranty information or technical support, please refer to the documentation provided at the time of purchase or contact EGLO customer service directly. Keep your purchase receipt as proof of purchase.

Image: The official EGLO brand logo.