EGLO is a leading international manufacturer of contemporary decorative lighting, smart home illumination systems, and ceiling fans.
EGLO is a globally recognized manufacturer of decorative lighting fixtures, headquartered in Tyrol, Austria. Since its founding in 1969, the company has expanded to over 50 countries, offering a vast portfolio of interior and exterior lighting solutions. Their product line ranges from modern ceiling lights, pendants, and wall lamps to high-performance ceiling fans and smart home lighting systems.
The brand is well-known for its "EGLO connect.z" smart lighting technology, which integrates Zigbee and Bluetooth for seamless control via apps, voice assistants like Alexa and Google Home, and remote controls. Whether for indoor ambiance or outdoor durability, EGLO focuses on combining current design trends with high functionality and energy efficiency.
Selected manuals from manuals+ curated for this brand.
Featured manuals are a limited selection. Search for more manuals.
Additional documents are a limited selection. Search all manuals.
Watch setup, installation, and troubleshooting videos for this brand.
Common questions about manuals, registration, and support for this brand.
To reset most smart enabled ceiling fans or lights, power OFF the device for more than 10 seconds, then power it UP again. Within 5 seconds, hold the specified button (e.g., '8H' or 'FAN OFF') on the remote until a beep is heard.
Many EGLO fans are designed for indoor use, though some models are suitable for covered outdoor areas (alfresco) provided they have at least two walls protecting them. They are not waterproof and must be shielded from direct water, wind, and dust.
EGLO connect.z systems can be controlled using the AwoX HomeControl app, available for smartphones and tablets. They are also compatible with voice assistants like Amazon Alexa and Google Home via Zigbee.
Generally, switch the power supply ON and within 10 to 30 seconds, aim the transmitter at the receiver and hold the 'FAN OFF' button (or other designated pairing button) until a beep sounds, confirming the pairing.
Ensure all electrical connections are secure and the correct bulb type is installed. Check the circuit breaker to ensure power is being supplied to the fixture.