1. Introduction
This manual provides essential information for the safe and effective use of the SKF LAGD 60/WA2 Automatic Grease Lubricator. The LAGD 60/WA2 is a disposable, single-point automatic lubricator designed to provide a continuous and precise supply of LGWA 2 grease to lubrication points, ensuring optimal performance and extended service life for machinery. It is particularly suited for applications requiring lubrication over wide temperature ranges and under extreme pressure conditions.
Please read this manual thoroughly before installation and operation to ensure proper handling and to prevent potential damage or injury.
2. Product Overview
The SKF LAGD 60/WA2 is part of the SKF SYSTEM 24 series, offering reliable automatic lubrication. Key features include:
- Capacity: 60mL (2.03 fl. oz.) disposable unit.
- Grease Type: Pre-filled with LGWA 2 grease, a mineral oil-based lithium complex grease.
- Application Suitability: Designed for applications involving wide temperature ranges and extreme pressure, such as conveyors, electric motors, pumps, and fans.
- Dispense Rate Setting: Features a transparent lubricant container for visual inspection and a dial for setting the dispense rate.
- Compact Design: Allows for installation in restrictive areas.
Figure 1: SKF LAGD 60/WA2 Automatic Grease Lubricator. This image displays the SKF LAGD 60/WA2 Automatic Grease Lubricator. It features a transparent container allowing visual inspection of the grease level, a blue top cap with a dial for setting the dispense rate, and a red hexagonal base for attachment. The label 'SKF SYSTEM 24 Automatic lubricator' is visible on the side.
3. Setup and Installation
- Preparation: Ensure the lubrication point is clean and free from old grease or contaminants.
- Mounting: Screw the LAGD 60/WA2 lubricator directly onto the lubrication point. Ensure a secure, hand-tight connection. Avoid overtightening. If direct mounting is not possible, use appropriate adapters or extension hoses (not included) to connect the lubricator to the lubrication point.
- Setting Dispense Rate:
- Determine the required grease quantity and dispense period for your application. Refer to machinery manufacturer specifications or use the SKF DialSet software/mobile app for calculation.
- Rotate the dial on the top of the lubricator to select the desired dispense period (e.g., 1, 3, 6, 12 months). The selected period indicates the time over which the 60mL of grease will be dispensed.
- Activation: Once the dispense rate is set, the lubricator will automatically begin dispensing grease. No further manual activation is required.
Important: The LAGD 60/WA2 is a single-use, disposable unit. Do not attempt to refill or disassemble the lubricator.
4. Operating Instructions
Once installed and activated, the SKF LAGD 60/WA2 operates autonomously.
- Monitoring: Periodically check the transparent container to visually inspect the remaining grease level. This allows you to anticipate when a replacement unit will be needed.
- Dispense Rate: The selected dispense rate is fixed once set. Do not attempt to change the setting after activation, as this may affect the lubricator's performance.
- Environmental Conditions: Ensure the lubricator is not exposed to extreme conditions beyond its specified operating temperature range, as this can impact dispense rate and grease consistency.
5. Maintenance
The SKF LAGD 60/WA2 is designed for maintenance-free operation throughout its service life.
- Visual Inspection: Regularly inspect the lubricator and the lubrication point for any signs of leakage, damage, or blockages.
- Replacement: Replace the entire unit with a new SKF LAGD 60/WA2 once the grease is depleted or at the end of the set dispense period.
- Disposal: Dispose of used lubricators according to local environmental regulations for industrial waste.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| No grease dispensed or very slow dispense rate. |
|
|
| Grease dispensing too quickly. |
|
|
| Leakage around connection. |
|
|
7. Specifications
| Model Number | LAGD 60/WA2 |
| Manufacturer | SKF |
| Capacity | 60 mL (2.03 fl. oz.) |
| Grease Type | LGWA 2 (Mineral oil-based lithium complex grease) |
| Dispense Period Options | Adjustable (e.g., 1, 3, 6, 12 months) |
| Operating Temperature Range | Refer to product packaging or SKF documentation for specific LGWA 2 grease temperature limits. |
| ASIN | B007VF9BPC |
8. Safety Information
- Always wear appropriate personal protective equipment (PPE) when handling lubricants and working with machinery.
- Keep out of reach of children.
- Do not ingest grease. In case of ingestion, seek medical attention immediately.
- Avoid prolonged skin contact. Wash hands thoroughly after handling.
- Do not expose the lubricator to open flames or excessive heat.
- Ensure proper ventilation when working in enclosed spaces.
- Dispose of used units and grease in accordance with local environmental regulations.
9. Warranty and Support
For specific warranty information, technical support, or inquiries regarding the SKF LAGD 60/WA2 Automatic Grease Lubricator, please contact SKF directly or visit their official website.
