Home ZKDIGIMAX ZKDIGIMAX DG04-GB3 Digital Display Price Tag Installation Guide
ZKDIGIMAX DG04-GB3 Digital Display Price Tag
Specifications
Model: DG04-GB3Version: 1.0 English
Dimensions:
Heat Dissipation Grill LED Indicator: 7.48″ (190.0mm)Wall Mounting Backplate Mounting Holes: 7.48″ (190.0mm)
Dimensions
Product Usage Instructions How to install the device on the wall?
Mark the location of the mounting holes with a pencil in a suitable place on the wall.
Drill 3 mounting holes in the marked locations and plug the expansion tubes.
Secure the backplate to the wall with screws. Note the directions.
Gently push the device bayonet into the backplate, then turn it clockwise until it clicks into the slot.
Required Hardware
Cross recessed countersunk head screw x 3
KA3 x 30mm
Expansion Tube x 3
M6 x 26mm
FCC FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
“This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.”
CONTACT INFORNATION
Teletech Park #03/32, 20 Science Park Road, 117674, Singapore.
www.zkdigimax.com .
Copyright © 2024 ZKDIGIMAX PTE.LTD. All rights reserved.
Due to regular upgrades of systems and products, ZKDIGIMAX could not guarantee exact consistency betweenthe actual product and the written information in this manual.
FAQs
Q: What should I do if I encounter interference issues with the device?
A: If you experience interference, try reorienting or relocating the receiving antenna. Additionally, ensure there is sufficient separation between your equipment and other devices that may cause interference.
Documents / Resources References
