A401 Portable Thermal Printer
“
Product Information
Specifications
- Product: Portable Thermal Printer
- Compliance: Part 15 of the FCC Rules
- RF Exposure: Meets general RF exposure requirements
- Usage: Portable exposure condition without restriction
Product Usage Instructions
Installation and Setup
- Ensure the printer is placed on a stable surface.
- Power on the printer using the provided power cable.
- Follow the printer’s specific setup instructions to connect it
to your device.
Printing Documents
- Load the thermal paper into the printer following the
manufacturer’s guidelines. - Send the document or image to be printed from your device to
the printer. - Press the print button on the printer to start printing.
Maintenance
- Regularly clean the printer’s exterior with a soft, dry
cloth. - Ensure the paper roll is replaced when it runs out to avoid
damage to the printer. - Refer to the user manual for troubleshooting steps in case of
any issues.
Frequently Asked Questions (FAQ)
Q: What should I do if the printer is not printing
correctly?
A: Check the paper roll for jams or ensure it is loaded
correctly. Also, verify the connectivity between your device and
the printer.
Q: Can I use third-party thermal paper with this printer?
A: It is recommended to use thermal paper provided by the
manufacturer to ensure optimal performance and print quality.
Q: Is it safe to use the printer in a portable exposure
condition?
A: Yes, the device has been evaluated to meet general RF
exposure requirements and can be used in portable exposure
conditions without restrictions.
“`
Portable Thermal Printer
FCC Warning Statement: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Documents / Resources
 |
ZIJIANG A401 Portable Thermal Printer [pdf] Instruction Manual A401, A401 Portable Thermal Printer, Portable Thermal Printer, Thermal Printer, Printer |