BSEED WIFI02-GF智能插座

产品特性

1. Using APP to control and operate the unit.
2. Using the gear switch to control and setting the time.

手术

• WIFI02 is a single output Smart WIFI timer socket.
• Use mobile software to control the on/off and countdown of the socket through WIFI connection.

1. Before using the device, you need to configure the network to connect the product to the Internet via WIFI, which can be either a router or a hot spot on a mobile phone. When the product is powered on, the display flashes OFF, long press the red button for 3S for connecting till the display shows “00.00” and stop to flash which means successful. If no need to distribution network, can press the red button or rotate the gear switch to be in “00.00” standby mode directly.
2. Two mode of red button: short press and long press.
   • In standby mode, short press to be ON, the socket is outputting continuously. Press again to stop the outputting.
   • Long press is to enter the status of the EZ distribution network. When the OFF is flashing, it can be connected according to the EZ configuration method; and exit the previously connected mobile phone signal;
3. There is a gear switch around the product casing. It has two mode of clockwise and counterclockwise.
   • In standby mode, rotating clockwise by 1 grid will increase the countdown timer by 15 minutes and display 00.15. Rotated clockwise continuously, the maximum display will be 24.00.
   • Conversely, rotate counterclockwise by 1 grid to reduce the countdown timer by 15 minutes, and rotate counterclockwise continuously until the minimum display is 00.00.

规格

• 产品型号： 无线网络02
• 产品尺寸： 67 × 67 × 84MM
• 颜色： 白色的
• 产品重量： 95克
• 输入音量tage: 230伏交流/50赫兹
  加载 力量： 16A Max. 3680W
• WIFI参数： Supports protocol 802.11 b/g/n; passageway 1-14@2.4GHz Support WPA/WPA2 security
• 功耗： ＜0.5W
• 系统支持： iOS 8.0 and above versions;
• 安卓4.4及以上手机

APP Step

To scanning the QR code as below for download the APP.

常见问题

文件/资源

BSEED WIFI02-GF智能插座 [pdf] 用户手册 WIFI02-GF智能插座插头，WIFI02-GF，智能插座插头，插座插头，插头

参考

• 用户手册