ZEBRA MC93 Charge Only Cup Conversion Instruction Manual

ZEBRA MC93 Charge Only Cup Conversion

Specifications

• Product Model: MC93
• Conversion Type: Charge Only Cup
• Installation Manual: MN-004756-01EN-P

Product Usage Instructions

Cup Removal

1. Disconnect the AC power from the cradle.
2. Using a Phillips screwdriver, remove the screw securing the charge-only cup to the cradle.
3. Slide the charge-only cup forward and lift it to remove.
4. Disconnect the charge-only cup cable from the connector.

Cup Installation

5. Connect the new charge-only cup cable to the connector.
6. Align the new charge-only cup with the cradle and slide it into place.
7. Secure the new charge-only cup to the cradle using a Phillips screwdriver.

Support and Information
Contact Zebra for support and information:

• Contact Zebra
• View Quick Answers and Knowledge Base
• Learn about product patent information
• Join Community Connection of Zebra users and ambassadors

Cup removal

CAUTION-ESD: This rework activity must be performed by a qualified technician or engineer in an ESD-safe workstation. The technician or engineer must wear a grounded ESD strap.

1. Remove the AC power from the cradle.
2. Remove the screw securing the charge-only cup to the cradle using a Phillips screwdriver.
3. Slide the charge-only cup forward and lift.
4. Disconnect the charge only cup cable from the connector.
5. Connect the new charge-only cup cable to the connector.
6. Align the new charge-only cup with the cradle and slide the ethernet cup backConnect the new charge only cup cable to the connector.
7. Using a Phillips screwdriver, secure the new charge-only cup to cradle with a screw.

Support and Information

• zebra.com/contactsupport
• zebra.com/knowledge
• ip.zebra.com
• zebra.com/supportcommunity

MORE INFORTMATIOJN

Zebra Technologies | 3 Overlook Point | Lincolnshire, IL 60069 USA
zebra.com
ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies
Corp., registered in many jurisdictions worldwide.

All other trademarks are the property of their respective owners.
© 2023 Zebra Technologies Corp. and/or its affiliates. All rights reserved.

FAQ

• Q: Who should perform the cup conversion?
  • A: The cup conversion should be performed by a qualified technician or engineer in an ESD-safe workstation wearing a grounded ESD strap.