ZALMAN M3 Plus mATX Mini Tower Computer Case
Precautions
Read this manual carefully before installing.
- Check the product and components before installing. If you find any abnormality, contact the location where you purchased the product for a replacement or refund.
- Wear gloves to prevent accidents when installing the product.
- Severe damage may occur when mounting the system, so do not apply excessive force.
- Connecting the cable incorrectly may cause a fire due to a short circuit. Make sure to refer to the manual when connecting the cable.
- Be careful not to block the ventilation hole of the product when using the system.
- Avoid locations with direct sunlight, water, moisture, oil, and excessive dust. Store and use the product in a well-ventilated location.
- Do not wipe the surface of the product using chemicals. (organic solvents such as alcohol or acetone)
- Do not insert your hand or other object into the product during operation, as this may injure your hand or damage the object.
- Store and use the product out of children’s reach.
- Our company assumes no responsibility for any problem that occurs due to the use of the product for purposes other than its designated purposes and/or the carelessness of the consumer.
- The exterior design and specifications of the product are subject to change without prior notice to consumers for quality improvement
Specifications
Model | M3 PLUS | |
Case Form Factor | mATX Mini Tower | |
Dimensions | 407(D) x 210(W) x 457(H)mm | |
Weight | 6.0kg | |
Case Materials | Plastic, Steel, Tempered Glass | |
Motherboard Support | mATX / Mini-ITX | |
Maximum VGA Length | 330mm | |
Maximum CPU Cooler Height | 165mm | |
Maximum PSU Length | 180mm | |
PCI Expansion Slots | 4 | |
Drive Bays | 2 x 3.5” / 4 x 2.5″ | |
Fan Support |
Top | 2 x 120mm |
Front | 3 x 120mm | |
Rear | 1 x 120mm | |
Bottom | 2 x 120mm | |
Pre-Installed Fan(s) | Front | 3 x 120mm (with White LED Effect) |
Rear | 1 x 120mm (with White LED Effect) | |
Radiator Support | Top | 240mm |
Side | 240mm | |
I/O Ports | 1 x Headphone Jack, 1 x Mic, 1 x USB3.0, 2 x USB2.0,
Power Button, Reset Button, Fan-LED Controller |
Accessories
I/O Ports
INSTALLATION
Removing the side panels
- Tempered Glass
- Steel Panel
Removing the front panel
Mounting the motherboard
Motherboard size
- mATX
- Mini-ITX
Mounting the PSU
Mounting the PCI-E(VGA) card
Mounting the 3.5″ HDD
Mounting the 2.5″ SSD / HDD
Mounting the radiator
- Top radiator
- Front radiator
Fans Included / Specifications
Mounting the fans
- Mounting the top fans
- Mounting the bottom fans
I/O Connectors
Documents / Resources
![]() |
ZALMAN M3 Plus mATX Mini Tower Computer Case [pdf] User Manual M3 Plus mATX Mini Tower Computer Case, M3 Plus, mATX Case, Mini Tower Computer Case, Computer Case, Tower Computer Case, Mini Case |
![]() |
ZALMAN M3 PLUS mATX Mini Tower Computer Case [pdf] User Manual M3 PLUS, M3 PLUS RGB, mATX Mini Tower Computer Case, Mini Tower Computer Case, Tower Computer Case, M3 PLUS, Computer Case |
![]() |
ZALMAN M3 PLUS MATX Mini Tower Computer Case [pdf] User Manual M3 PLUS MATX Mini Tower Computer Case, M3 PLUS, MATX Mini Tower Computer Case, Mini Tower Computer Case, Tower Computer Case, Computer Case, Case |