YSI Logo 1Quick Start Guide
Item #626972
BC

626972 Optical Dissolved Oxygen

This is a reference guide for operating the ProDIGITAL line of handhelds. Refer to the User Manual for more information.

YSI 626972 Optical Dissolved Oxygen

Setting Up

YSI 626972 Optical Dissolved Oxygen - Charge Charge the battery by connecting the handheld to an AC power supply or USB connector using the micro USB cable. Ensure all components are dry when charging. A full charge takes approximately 9 hours.
YSI 626972 Optical Dissolved Oxygen - logging mode Make sure the date/time is correct and set the logging mode (Single or Continuous).
YSI 626972 Optical Dissolved Oxygen - displayed Setup sensor parameters and select units displayed on the Run and Data View screens.
YSI 626972 Optical Dissolved Oxygen - Calibrate Calibrate sensors prior to taking measurements; sensor-specific calibration instructions can be found in the User Manual.

Taking Measurements

YSI 626972 Optical Dissolved Oxygen - Insert Insert the probe into the sample and briefly move it up and down to release any air bubbles. Allow measurements to stabilize and press the Enter key to log data.
To stop Continuous logging, simply press the Enter key again.

Data Management

YSI 626972 Optical Dissolved Oxygen - key Press the File key to view, delete, or backup logged data. Data can be filtered by date/time and by the user-created Site and/or Data ID.
YSI 626972 Optical Dissolved Oxygen - KorDSS Transfer data to your PC using KorDSS Software. Make sure the instrument driver and software are installed from the included USB flash drive or from YSI.com.

  1. Open KorDSS Software.
  2. Use the micro USB cable to connect the handheld to the PC.
  3. Power on the handheld; there may be a short delay before it shows  up in the software.
  4. Select the handheld under the Instrument Connection Panel and click Connect.
  5. Click Start Download from Device.
  6. After data download, click View Logged Data to view, print, and export data files from KorDSS.

YSI Logoa xylem brand
1725 Brannum Lane
Yellow Springs, OH 45387
800-765-4974, 937-767-7241
info@ysi.com
Item# 626972 Dwg# 626972
December 2019 Rev E
Learn from the experts
YSI.com/ProDSS-TrainingYSI Logo 2Distributed by:
Air-Met Scientific Pty Ltd
Air-Met Sales/Service
P: 1800 000 744
F: 1800 000 774
E: sales@airmet.com.au
Air-Met Rental
P: 1300 137 067
E: hire@airmet.com.au
W: www.airmet.com.au

Documents / Resources

YSI 626972 Optical Dissolved Oxygen [pdf] User Guide
626972, 626972 Optical Dissolved Oxygen, 626972, Optical Dissolved Oxygen, Dissolved Oxygen, Oxygen

References

Leave a comment

Your email address will not be published. Required fields are marked *