Payne Arduino DIY Control Remote
Incwadana yokuhambisa
Ngaphezuluview
I-Payne DIY Remote Control Transmitter iyilwe nguPayne Pan njengokufunda kunye ne-DIY elula. Ngoku iguqula i-Version 4, i-V4 esekelwe kwi-Arduino Nano, i-Nano ine-usb-ttl chip ebhodini, ngoko Ikulungele ngakumbi ukulayisha i-firmware, i-V4 isebenzisa i-1S Li-Po njengebhetri endaweni yokusebenzisa iibhetri ze-4 AAA; kunye nezinye iimpawu zongezwa
- Lungisa useto
- Ukulinganisa iintonga
- Lungisa imida ye-1-4 yamajelo
I-Payne Open Source RC kuphela i-PPM ephumayo, kwaye ayinayo imodyuli ye-RF, ungasebenzisa enye imodyuli ye-Tx okanye uzenzele yona (efana nemodyuli ye-"Multi Protocol TX") Ekubeni yeyokufunda, akukho layisensi, okanye iwaranti enikezelwayo. Vula umthombo kwi-Arduino IDE, ukhethe ibhodi "Arduino Pro okanye Pro min". iprosesa njenge "ATmega 328p(5v,16M)", emva koko unokuqulunqa kwaye ulayishe i-firmware. Ndiyathemba uyonwabela!
Imisebenzi ekhethekileyo
Sch kunye nePCB
Umthombo
iqhotyoshelwe apha ngezantsi
I-Solder iyanceda
I-DIY inomdla womlingo
Payne Arduino DIY Remote Control Transmitter Manual- Khuphela [kulungisiwe]
Payne Arduino DIY Remote Control Transmitter Manual- Khuphela
