Payne Arduino DIY Remote Control
Akwụkwọ ntuziaka nnyefe
gafereview
Payne DIY Remote Control Transmitter bụ nke Payne Pan mere maka mmụta na DIY dị mfe. Ugbu a ọ evolves Version 4, V4 dabeere Arduino Nano, Nano nwere usb-ttl mgbawa na osisi , otú Ọ bụ ihe adaba maka na-ebugote firmware, V4-eji 1S Li-Po dị ka batrị kama iji 4 AAA batrị; na-agbakwunyere atụmatụ ndị ọzọ
- Tọgharịa ntọala
- calibrate osisi
- Hazie oke maka ọwa 1-4
Payne Open Source RC na-emepụta naanị PPM, ma ọ nweghị modul RF, ị nwere ike iji modul Tx ọzọ ma ọ bụ nke emebere onwe ya (dịka "Multi Protocol TX") ebe ọ bụ maka ọmụmụ ihe, enweghị ikike, ma ọ bụ akwụkwọ ikike enyere. Mepee isi mmalite na Arduino IDE, họrọ bọọdụ “Arduino Pro ma ọ bụ Pro min”. Nhazi dị ka “ATmega 328p (5v,16M)”, mgbe ahụ ị nwere ike chịkọta ma bulite ngwa ngwa. Echere na ị ga-anụ ụtọ ya!
Ọrụ pụrụ iche
Sch na PCB
Isi mmalite
jikọtara n'okpuru
Solder na-enyere aka
N'onwe Gị bụ anwansi na-adọrọ mmasị
Akwụkwọ ntuziaka Payne Arduino DIY Remote Control Transmitter – Download [kachasị]
Akwụkwọ ntuziaka Payne Arduino DIY Remote Control Transmitter – Budata
