WOLF New Pro Induction Range User Manual

WOLF-LOGO

WOLF New Pro Induction Range

WOLF-New-Pro-Induction-Range-PRODUCT

Pro Induction Ranges

WOLF-New-Pro-Induction-Range-FIG-1

DIMENSION

WOLF-New-Pro-Induction-Range-FIG-2 WOLF-New-Pro-Induction-Range-FIG-3

Planning Information
Follow all minimum clearances to combustible surfaces shown in the illustrations on the following pages. For 48″ (1219) models only, two separate electrical supplies are required. For ease of installation, the receptacles should be positioned with the grounds facing each other to prevent cord interference.WOLF-New-Pro-Induction-Range-FIG-4

Electrical Requirements
Installation must comply with all applicable electrical codes. Locate the electrical supply flush with the wall or floor. A separate circuit servicing only this appliance is required. If a power supply cord is used, the cord must be designated for use with ranges and rated for 240 V, 50 amps, and must include 3 or 4 conductors. A 4-conductor cord is required for installations where grounding through the neutral is prohibited. Performance may be compromised if the electrical supply is less than 240 volts.

IMPORTANT NOTE: Two separate electrical services are required for 48″ (1219) models.

ELECTRICAL REQUIREMENTS

  • Electrical Supply grounded, 240/208 VAC, 60 Hz
  • Service* 50 amp dedicated circuit
    • Two for 48″ (1219) models.

WOLF-New-Pro-Induction-Range-FIG-5

 

Installation

WOLF-New-Pro-Induction-Range-FIG-6

  • Without ventilation hood, 36″ (914) minimum clearance countertop to combustible materials.

Two electrical supplies for 48″ (1219) models only.

NOTE: The shaded area above the countertop indicates minimum clearance to combustible surfaces. Combustible matoria/s cannot bo located within this area. For island installation, 12″ (305) minimum clearance back of range to combustible roar wall above the countertop,

OPENING WIDTH /W /A

  • 30″ Range 30″ (762) 101/4″ (260)
  • 36″ Range 36″ (914) 161/4″ (413)
  • 48″ Range 48″ (1219) 181 /4″ (464)

Wolf Residential Limited Warranty

Wolf Appliance Residential Warranty

FOR RESIDENTIAL USE FULL TWO-YEAR WARRANTY
For two years from the date of original installation, this Wolf Appliance product warranty covers all parts and labor to repair or replace, under normal residential use, any part of the product that proves to be defective in materials or workmanship. All service provided by Wolf Appliance under the above warranty must be performed by Wolf Factory Certified Service unless otherwise specified by Wolf Appliance, Inc. Service will be provided during normal business hours.

LIMITED FIVE-YEAR WARRANTY
For five years from the date of original installation, Wolf Appliance will repair or replace the following parts that prove to be defective in materials or workmanship: gas burners (excludes appearance), electric heating elements, blower motors (ventilation hoods), electronic control boards, magnetron tubes and induction generators. If the owner uses Wolf Factory Certified Service, the service provider will repair or replace these parts with the owner paying for all other costs, including labor. If the owner uses a non-certified service, the owner must contact Wolf Appliance, Inc. (using the information below) to receive repaired or replacement parts. Wolf Appliance will not reimburse the owner for parts purchased from non-certified services or other sources.

TERMS APPLICABLE TO EACH WARRANTY
The warranty applies only to products installed for normal residential use. The warranty applies only to products installed in any one of the fifty states of the United States, the District of Columbia or the ten provinces of Canada. This warranty does not cover any parts or labor to correct any defect caused by negligence, accident or improper use, maintenance, installation, service or repair.

THE REMEDIES DESCRIBED ABOVE FOR EACH WARRANTY ARE THE ONLY ONES THAT WOLF APPLIANCE, INC. WILL PROVIDE, EITHER UNDER THIS WARRANTY OR UNDER ANY WARRANTY ARISING BY OPERATION OF LAW. WOLF APPLIANCE, INC. WILL NOT BE RESPONSIBLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES ARISING FROM THE BREACH OF THIS WARRANTY OR ANY OTHER WARRANTY, WHETHER EXPRESS, IMPLIED OR STATUTORY.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other legal rights that vary from state to state. To receive parts and/or service and the name of Wolf Factory Certified Service nearest you, contact Wolf Appliance, Inc., P.O. Box 44848, Madison, WI 53744; check the Product Support section of our website, wolfappliance.com, email us at customerservice@subzero.com or call 800-222-7820.

  • Stainless steel (doors, panels, handles, product frames, and interior surfaces) is covered by a limited 60-day parts and labor warranty for cosmetic defects.
  • Replacement filters for ventilation hood recirculating kits are not covered by the product warranty.
  • WOLF APPLIANCE, INC. P.O. BOX 44848 MADISON, WI 53744 WOLFAPPLIANCE.COM 800.222.7820

Specifications

  • Product Name: New Pro Induction Range
  • Electrical Supply: Grounded, 240/208 VAC, 60 Hz 50 amp dedicated circuit
  • Required Electrical Service: Two for 48 (1219) models

FAQS

Q: What are the electrical requirements for the New Pro Induction Range?
A: The electrical supply should be grounded, 240/208 VAC, 60 Hz with a 50 amp dedicated circuit. For the 48-inch model, two separate electrical services are required.

Q: Why is it necessary to have two separate electrical supplies for the 48-inch model?
A: Having two separate electrical supplies for the 48-inch model ensures proper power distribution and prevents issues like cord interference during installation.

Documents / Resources

PDF thumbnailNew Pro Induction Range
User Manual · New Pro Induction Range, Pro Induction Range, Induction Range, Range

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.