WebRelay X-WR-441W Remote Relay Control User Guide

Basic Setup Steps

1. Power the module and connect via ethernet to a computer.
2. Set IP address on computer to the same network as module. (Ex: 192.168.1.50) Note: restore computer settings after setup.
3. To configure module, open web browser and enter: http://192.168.1.2/setup.html
4. In General Settings under WiFi, enter the WiFi settings.
5. Assign the module a permanent IP address or enable DHCP.
6. Restart the module for the settings to take effect.

Factory Default Settings

IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Control Page Web Address: http://192.168.1.2
Control Password: (no password set)
Setup Page Web Address: http://192.168.1.2/setup.html
Setup Username: admin
Setup Password: webrelay (all lower case)

C: Relay Contact Common
NO: Relay Contact Normally Open
NC: Relay Contact Normally Closed
V IN+: Power Supply Input (9-28VDC)
V IN-: Power Supply Input (Ground)
INPUT-: Optically-Isolated Input (-)
INPUT+: Optically-Isolated Input (+) +5V OUT: 5VDC Output

Documents / Resources

WebRelay X-WR-441W Remote Relay Control [pdf] User Guide X-WR-441W Remote Relay Control, X-WR-441W, Remote Relay Control, Relay Control, Control

References

• User Manual